Runco CR-32HD, CR-40HD manual ISF Calibration Service, Picture in Picture PIP, Stereo Sound / SAP

Page 3

ISF Calibration (Service)
Picture Adjust	25
White Balance	25
Blue Enable	26
DNR	26
Gamma	26
Baud Rate	26
Command ACK	26
Factory Reset	26
Splash Duration	26
Picture in Picture (PIP)
Displaying the Picture in Picture (PIP)	27
Changing the PIP Position	28
Changing the PIP Size	28
Selecting the Image Size in the PIP	28
Selecting the Image Mode in the PIP	28
Swapping the Main & Sub-Picture	29
Swapping the Main & Sub-Sound	29
Changing the PIP Aspect Ratio	30
Stereo Sound / SAP
Listening to Stereo Sound / SAP	31
RS-232 Configurations
RS-232C Configurations	32
Serial Protocol	33
Signals Supported
Standard Display Mode	35
Pin Configuration (PC/DVI)
PC Input Connector (D-Sub 15Pin)	36
DVI-D Connector	36
Troubleshooting
For Display Panel	37
For Monitor	38
Specifications	39
Dimensions	40

3

Image 3

Contents CR-32HD / CR-40HD Table of Contents Pin Configuration PC/DVI ISF Calibration ServiceRS-232 Configurations Signals SupportedWhat is Covered Under the Terms of this Limited Warranty One Year Limited WarrantyRIGHTS, Limits and Exclusions Runco INTERNATIONAL, INC Introduction DOC compliance Notice PrecautionsPower Indicator Status CR-32HD and CR-40HDFront View Input2 CR-32HD Rear View Input Panel13 14 CR-40HD Rear View Input Panel100 Remote ControlConnecting to the Video ConnectionsOr INPUT2 Connecting to a DVD or DTV Set-Top Box Input RCA or DVI Using the Monitor OUT featureTo use the display as a PC Monitor Connecting to a PCSetting the PC Properties Connecting Headphones Basic Operations Connecting the Power Cord and Switching Display On / OffVirtualwide mode Anamorphic modeStandard 43 mode Letterbox modeRestore Settings Selecting Picture AdjustPress the Menu button on the remote control Save SettingsSelecting Channel Selecting AudioSelecting Timer Setup PC Mode AdjustOSD Language CC1 CC2 CC3 CC4 Text1 Text2 Text3 Text4 Parental Control CaptionInput Selection Monitor OutOverscan White Balance ISF Calibration ServicePicture Adjust ISF CalibrationGamma Blue Enable DNR Digital Noise ReductionCommand Ack Factory ResetPicture in Picture PIP Displaying the Picture in Picture PIPSmall Twin Off Selecting the Image Size in the PIP Selecting the Image Mode in the PIPChanging the PIP Position Changing the PIP SizeSwapping the Main & Sub-Sound Swapping the Main & Sub-PictureChanging the PIP Aspect Ratio Wide 169 modeBroadcasting Stereo Sound / SAPListening to Stereo Sound / SAP OptionRS-232 Configurations RS-232C ConfigurationsPin 1 Ground Serial Protocol ‘\n’Timer OFF Mode Freq Hz Freq KHz Signals SupportedPin Configuration PC/DVI PC Input Connector D-Sub 15PinDVI-D Connector For Display Panel TroubleshootingFor Monitor CR-32HD SpecificationsCR-40HD DimensionsRUMA-011095