Dish Network 104333 AUX Auxiliary Mode for Cable TV Box, AUX Auxiliary Mode for Cable TV BOX

Page 12

AUX (Auxiliary) Mode for Cable TV Box

NUMBER BUTTONS

Use these buttons to enter numbers in a menu.

AUX (AUXILIARY) MODE FOR CABLE TV BOX

Some of the features described below may not apply to the cable TV box. See your cable box owner’s manual for details about the box’s features. If a remote control button is not described in this section, it does not work for a cable TV box.

AUX MODE BUTTON

To use the remote to operate a cable TV box, you must first set up the remote to control the cable box. See Controlling a Device on page 15. Then, you must press the AUX mode button to set the remote to AUX mode. The AUX mode button’s back light turns ON to show that the remote is set to AUX mode. Make sure to keep the remote in AUX mode to use the buttons as described in this section.

MUTE BUTTON

Press this button to turn off the sound. Press it again to restore the sound.

VOLUME BUTTON

Press the left-hand, minus (-) side of this button to lower the sound volume. Press the right-hand, plus (+) side of this button to raise the sound volume.

12

104333

Image 12
Contents Table of Contents Remote Control Signals UHF or IR About the Remote ControlRemote Control Signals UHF or IR Installing Batteries in the Remote Control Installing Batteries Remote ControlRemote Control Modes SAT Satellite Receiver Mode Using the Remote Control ButtonsSAT Satellite Receiver Mode Power Button Themes menu Important System Information menu TV Television Mode TV Television ModePress this button to turn the television on or OFF VCR VideoCassette Recorder Mode VCR Videocassette Recorder ModeUP/DOWN/LEFT/RIGHT Arrow Buttons AUX Auxiliary Mode for Cable TV Box AUX Auxiliary Mode for Cable TV BOXAUX Auxiliary Mode for Tuner or Amplifier AUX Auxiliary Mode for Tuner or AmplifierAUX Auxiliary Mode for Tuner or Amplifier Remote Control Procedures Controlling a DeviceControlling a Device Changing the Remote Control Address Changing the Remote Control AddressInstalling an Attenuator Installing AN AttenuatorControlling Sound Volume Controlling Sound VolumeTo switch back to TV volume control, do the following Doing the Device Code Scan Doing the Device Code ScanFinding the Device Codes Finding the Device CodesTVS Device CodesVcrs ITT TUNERS/AMPLIFIERS Cable TV BoxesTROUBLE-SHOOTING Table What Is Possible Reason What to Do HappeningUHF Limited Warranty United States of AmericaAdvance Exchange Program See the Trouble-Shooting Table on pag e26 If YOU Need Help104333 104333