Dish Network 104333 warranty Installing an Attenuator, Installing AN Attenuator

Page 17

Installing an Attenuator

4. Press the Pound (#) button. If the address you entered is valid for the remote control, the SAT mode button backlight flashes three times.

5. Press the Record button.

The Remote Address on the Important System Information menu should match the one that you entered.

6. To check the address, press and hold the SAT mode button for three seconds. Then, press the Pound (#) button twice. The SAT mode button backlight flashes the same number of times

as the address.

7. Press the Select button.

INSTALLING AN ATTENUATOR

Unwanted UHF signals may block signals from the remote control to the receiver. To prevent such blockage, you can install a 10 dB attenuator. This will help keep out other UHF signals, but also reduce the distance at which you can use the remote control.

1. Remove the UHF antenna from the UHF Remote Antenna connection on the receiver back panel.

2. Attach a 10 dB attenuator to the

UHF Remote Antenna

connection.

3. Attach the UHF antenna to the attenuator.

104333

17

Image 17
Contents Table of Contents Remote Control Signals UHF or IR Remote Control Signals UHF or IRAbout the Remote Control Remote Control Modes Installing Batteries in the Remote ControlInstalling Batteries Remote Control SAT Satellite Receiver Mode SAT Satellite Receiver ModeUsing the Remote Control Buttons Power Button Themes menu Important System Information menu TV Television Mode TV Television ModePress this button to turn the television on or OFF VCR Videocassette Recorder Mode VCR VideoCassette Recorder ModeUP/DOWN/LEFT/RIGHT Arrow Buttons AUX Auxiliary Mode for Cable TV BOX AUX Auxiliary Mode for Cable TV BoxAUX Auxiliary Mode for Tuner or Amplifier AUX Auxiliary Mode for Tuner or AmplifierAUX Auxiliary Mode for Tuner or Amplifier Controlling a Device Remote Control ProceduresControlling a Device Changing the Remote Control Address Changing the Remote Control AddressInstalling AN Attenuator Installing an AttenuatorControlling Sound Volume Controlling Sound VolumeTo switch back to TV volume control, do the following Doing the Device Code Scan Doing the Device Code ScanFinding the Device Codes Finding the Device CodesDevice Codes TVSVcrs ITT Cable TV Boxes TUNERS/AMPLIFIERSWhat Is Possible Reason What to Do Happening TROUBLE-SHOOTING TableUHF United States of America Limited WarrantyAdvance Exchange Program If YOU Need Help See the Trouble-Shooting Table on pag e26104333 104333