Doing the Device Code Scan
DOING THE DEVICE CODE SCAN
If a device is not listed in the tables or if the listed codes do not work, you can scan through all the codes, testing each one. Remember that the remote may not control some devices.
1. Press and hold the mode button for the device, |
|
for about three seconds. When all the other |
|
mode button backlights come on, release the |
|
button. It will flash to show that the remote is | For example |
ready for address setting. |
|
2. For AUX mode only, use the number buttons to enter a number as follows: 0 is for a second TV, 1 is for a second VCR, and 2 is for an audio amplifier or cable TV box. Then, press the Star (*) button.
3. Press the Power button.
4. Press the Up or Down arrow button to set the remote to the next code. The Down arrow button scans backward, and the Up arrow button scans forward. Press the button again
to continue scanning.
5. When the remote reaches the correct code, the device turns OFF. If this happens, press the Pound (#) button to store the code in the remote. If the code is valid, the matching mode light blinks three times.
6. Press the Power button to turn the device back ON.
7.Try some other remote control buttons to make sure that you have the right code.
20 | 104333 |