Dish Network 104333 warranty SAT Satellite Receiver Mode, Using the Remote Control Buttons

Page 4

SAT (Satellite Receiver) Mode

USING THE REMOTE CONTROL BUTTONS

SAT (SATELLITE RECEIVER) MODE

Some of the features described below may not apply to your satellite receiver. See the receiver User Guide for details about the receiver’s features. If a remote control button is not described in this section, it does not work in SAT mode.

SAT MODE BUTTON

The remote control already is set up to control the satellite receiver. But, you must press the SAT mode button to set the remote to SAT mode. The SAT mode button’s back light turns ON to show that the remote is set to SAT mode. Make sure to keep the remote in SAT mode to use the buttons as described in this section.

AUX MODE BUTTON

Set up the remote to control the television and do not setup the remote in AUX mode. If you do this, then with the remote in SAT mode you can press the AUX mode button to turn the television ON or OFF.

This allows you to turn the TV on or off without leaving SAT mode.

TV/VIDEO BUTTON

If you connect the receiver using only its back panel RF or VHF connections, use this button to switch the receiver between the satellite signal (routed into the receiver’s Satellite In input) and another video signal such as cable or broadcast TV antenna input (routed into the receiver’s TV Antenna Cable In input).

MENU BUTTON

Press this button to open the Main Menu.

4

104333

Image 4
Contents Table of Contents About the Remote Control Remote Control Signals UHF or IRRemote Control Signals UHF or IR Installing Batteries Remote Control Installing Batteries in the Remote ControlRemote Control Modes Using the Remote Control Buttons SAT Satellite Receiver ModeSAT Satellite Receiver Mode Power Button Themes menu Important System Information menu TV Television Mode TV Television ModePress this button to turn the television on or OFF VCR VideoCassette Recorder Mode VCR Videocassette Recorder ModeUP/DOWN/LEFT/RIGHT Arrow Buttons AUX Auxiliary Mode for Cable TV Box AUX Auxiliary Mode for Cable TV BOXAUX Auxiliary Mode for Tuner or Amplifier AUX Auxiliary Mode for Tuner or AmplifierAUX Auxiliary Mode for Tuner or Amplifier Controlling a Device Remote Control ProceduresControlling a Device Changing the Remote Control Address Changing the Remote Control AddressInstalling an Attenuator Installing AN AttenuatorControlling Sound Volume Controlling Sound VolumeTo switch back to TV volume control, do the following Doing the Device Code Scan Doing the Device Code ScanFinding the Device Codes Finding the Device CodesTVS Device CodesVcrs ITT TUNERS/AMPLIFIERS Cable TV BoxesTROUBLE-SHOOTING Table What Is Possible Reason What to Do HappeningUHF Limited Warranty United States of AmericaAdvance Exchange Program See the Trouble-Shooting Table on pag e26 If YOU Need Help104333 104333