Changing the Remote Control Address
8.If the code you entered does not work, repeat steps 3 through 7 using another code from the tables.
9.If you have tried all of the codes listed for the device without success, or if you cannot find the device brand name in the tables, see Device Code Scan on pag e20.
CHANGING THE REMOTE CONTROL ADDRESS
Note: Do not change the address of the remote unless absolutely necessary, because the remote cannot control the receiver if the two devices have different addresses. If you start doing this procedure and then do not press any button for 20 seconds, the remote will end the procedure. Just start over again.
Note: This procedure shows examples of menu options. The options that you see may differ.
1.Display the Important System Information menu. Note the Remote Address shown on this menu.
To do this:
Either: Press the System Information |
| ||
button. | or: | ||
or: a) | Press the Menu button. | ||
| |||
b) | Select the System Setup option. |
| |
| Note: This step does not apply |
| |
| to some receivers. |
| |
c) | Select the Installation option. |
| |
d) | Select the System Info option. |
| |
2. Press and hold the SAT mode button about three seconds, until all the mode button backlights come on, and then release the SAT button.
3. Use the number buttons to enter a number from 1 to 15. The SAT mode button backlight will blink off after you enter each digit, and then come on again.
16 | 104333 |