Configuration
Viewing the Setup Menu
You can use the RV Series Remote Controls to configure the RV Series Inverter/Charger and the remote itself. Configuration is performed using the Setup menu. You can view the Setup menu and configure settings by using the Setup/Menu Item buttons and the Settings button.
To view the Setup menu and enter Setup mode, press and hold the two Setup/Menu Item buttons for approximately five seconds, or until the screen clears, then release the buttons.
You can scroll through menu items by pressing the up or down arrow buttons.
To exit Setup mode, press and hold the Setup/Menu Item buttons for approximately five seconds until the screen changes back to the System Status Display.
Menu Item
Meter Mode
Setup
Figure 3-1 Setup/Menu Item Buttons
Changing Settings
You can change settings using the Settings button while in Setup mode. This button scrolls through menu items one at a time. If you pass the desired item or setting, continue pressing the Settings button until the item or setting reappears.
You can also use the Settings button to enable or disable the equalize charge mode.
Settings
Figure 3-2 Settings button
12 |