Operation
Charger Fault
The “Charger Fault” System Status message appears when an internal error is detected in the inverter/charger during charging. In addition, the red Error LED is on and the buzzer sounds. After 15 minutes, the charge relay disconnects and the inverter section shuts down. The screen shows “System Status: Overload.”
This fault indicates a hardware failure in the charger circuitry of the inverter/charger. If this message appears, contact Xantrex or the nearest Service Center.
Inverter
Charge | System Status: | ! |
Batt. Full | Charger Fault | |
| ||
Error | Error Condition | Buzzer sounds |
| ||
| (press arrow | |
| Error LED ON | button to cancel) |
Figure 4-17 Charger Fault Error Message
40 |