Zenith HCS5610 AUX Controller Connection and Placement, IR Receiver & IR Bracket Installation

AUX Controller: Connection and Placement

Connect the AUX Controller to allow the Integrator Box to operate your AUX device.

1

2

Connect the AUX Controller to the AUX CONTROL cord on the TV/STB.

Place the AUX Controller under and in front of the AUX device.

The AUX Controller must extend just out in front of the infrared sensor on the AUX device.

*Note:

If the infrared sensor is not marked on your AUX device, shine a flashlight into the front panel of the AUX device to locate the sensor.

						AC OUT	AC IN
		AUDIO IN	AUDIO OUT		RS-232C
REMOTE
IN
RJP
INTERFACE	1	2
AUX		DIGITAL	DIGITAL	DIGITAL AUDIO	DISPLAY	MAX 8A 960W	AC 120V~ 60Hz
CONTROL		VIDEO IN	VIDEO OUT	OUT (OPTICAL)	CONTROL

Connections Panel

AUX Controller

DVD 1/2”

IR Sensor (Side View) to 1”

DVD (Front View)

IR Receiver & IR Bracket Installation

Install the IR Receiver and Bracket Assembly to the back of the monitor using the method described below. The IR Receiver should be installed in the IR Bracket. When the IR Bracket assembly is attached to the TV, it should be mounted with two-sided tape on the bottom-back side of the TV. The IR receiver should be aimed toward the TV viewer and be visible at the bottom front of the TV, in order that it be able to receive IR sig- nals from the user remote.

Monitor

IR Receiver

IR Bracket

						AC OUT	AC IN
		AUDIO IN	AUDIO OUT		RS-232C
REMOTE
IN
RJP
INTERFACE	1	2		DIGITAL AUDIO
AUX		DIGITAL	DIGITAL		DISPLAY	MAX 8A 960W	AC 120V~ 60Hz
CONTROL		VIDEO IN	VIDEO OUT	OUT (OPTICAL)	CONTROL

Connections Panel

IR Receiver & Bracket Installation

THE IR RECEIVER UNIT IS PROVIDED. THIS WILL NEED TO BE MOUNTED ON THE MONITOR BACK WITH TWO-SIDED TAPE.

P A G E 1 0