Zenith HCS5610 warranty Glossary of Terms, OHM RF Cable

Page 71

Glossary of Terms

A list of definitions for some of the words found in this guide

75 OHM RF CABLE

The wire that comes from an off-air antenna or cable service provider. The end looks like a hex-shaped nut with a wire sticking through the middle. It screws onto the Antenna/Cable threaded jack on the back of the TV/STB.

300 TO 75 OHM ADAPTER

A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack.

They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end.

ANALOG TELEVISION

Standard television broadcasting format in 4:3 picture aspect ratio.

A/V CABLES

Audio/Video cables. Three cables bunched together—right audio (red), left audio (white), and video (yellow). A/V cables are used for stereo playback of videocassettes and for higher quality picture and sound from other A/V devices.

A/V DEVICE

Any device that produces video or sound (VCR, DVD, cable box, or television).

AMPLIFIER

An electronic device that amplifies sound from a television, CD player, VCR, DVD, or other Audio/Video device.

ANTENNA

The physical receiver of television signals sent over the air. A large metal piece of equipment does not always have to be visible to be using an antenna.

CABLE

Cable service box. Refers to the descrambler box cable subscribers use to receive cable programming signals.

CATV

Programming provided by a cable service.

DIGITAL TELEVISION

High-resolution, cinema-quality television signals transmitted digitally.

DVI

Digital Video Interface

Accommodates analog and digital interfaces with a single connector.

COMPOSITE VIDEO

Typical video jack, uses one wire for transporting three-color video signals.

COMPONENT VIDEO

Uses three wires for transporting three-color video signals. The end result is usually better video quality.

DELETED

Lets you remove channels from the list that the end user can scroll through using CH (Channel) Up/Down.

HDMI

High-definition multimedia interface.

HDTV

High-definition television. Refers to television signals that have higher resolution than ordinary analog TV signals.

HDSTB

High-definition set top box. Refers to a tuner device that receives high-definition television signals which have higher resolution than ordinary analog TV signals.

INPUT

Refers to the input jack that receives a signal from a TV, VCR, DVD Player or other Audio/Video device.

JACK

An input or output connector on the back of a TV, VCR, DVD Player or other Audio/Video device.

MONO SOUND

Mono (monaural) sound is one channel of sound. On more than one speaker, all the speakers play the same audio.

OUTPUT

Refers to the output jack that sends a signal out of a VCR, DVD, or other A/V device.

PHYSICAL CHANNEL NUMBER

Actual digital major, dashed minor channel number that a station is broadcasting on.

RGB (Red, Green, Blue)

Connection input or output port available for producing a video image using three separate colors: Red, Green, and Blue.

2ND AUDIO PROGRAMMING/SAP

Second Audio Programming (SAP) is another, separate audio channel available with some programming. Choosing SAP often refers to listening to audio in another language, such as Spanish or French.

SIGNAL

Picture and sound traveling through a cable, or over the air, to the TV.

STEREO SOUND

Stereo (Stereophonic) sound refers to audio that’s divided into right and left sides.

TUNER

Device that picks up the broadcast signal and turns it into picture and sound.

VIRTUAL CHANNEL NUMBER

The arbitrarily assigned digital dashed minor channel number that a station is broadcasting on.

P A G E 7 1

Image 71
Contents B l e o f c o n t e n t s Installer quick setup guide Installation and Operating Guide WarrantySerial no Record the Model NumberMillbrook Drive Lincolnshire, IL 60069, USA. Phone G ENEC National Electrical Code Important Safety InstructionsTable of Contents Setup Checklist Status LED flashes while the program is running Installation/Connections OverviewMonitor Ventilation VentilationMonitor/Integrator Box Wall Mounting System Ventilation / Installation OverviewIR Receiver & IR Bracket Installation AUX Controller Connection and PlacementMini glossary Antenna HookupG E 1 Connect cable service to the HD Integrator Box System Cable Service HookupRS-232C Control Connections Connect Aux Control IR Output as required of your system Viewing Equipment SetupComputer PC Hookup DVI DVI Hookup to RJP or DVD PlayerTV/Monitor TV/Monitor RJP ConnectionsAudio Connection Digital Audio Optical Connections On-Screen Menus Overview Info Other Menus & On-Screen DisplaysG E 2 User Remote Control Key FunctionsChannel -/+ Installer Remote Control Key FunctionsNumber Keypad MuteAuto Program Channel Search Channel List Channel ListChannel Control OK Enter button Press the ADJ F or G button to adjustSignal being received On-Off Timers Setup Clock SetupSee the next Enter buttonUse the ADJ D E F G buttons to set the Daylight Savings Time Zone options for your local areaPress the OK Enter button Use the ADJ D or E button to highlight Time Zone and pressUse the ADJ F or G button to select the Time Zone Use the ADJ D or E button to highlight the Daylight SavingYou can set a time for the TV to automatically turn-off You can set a time for the TV to automatically turn-onUse the ADJ D E F G buttons to choose AM / PM, Hours Minutes and time period to turn-onG E 3 Use the ADJ D or E button to highlight Auto Off and pressUse the ADJ D or E button to choose On or Off OK Enter button ChipUse the ADJ D or E button to choose 1~12 hours and press Enter the 4 digits passwordThis option sets up hour that you wish to block Use the ADJ D or E button to highlight Set Block HourDescription of the TV FCC Rating Codes Use the ADJ D E F G buttons to choose and set up the menuOptions for Tvpg Rating Use the ADJ D or E button to highlight the Mpaa Rating Options for Mpaa RatingDescription of the Mpaa and TV FCC Rating Codes Options for Can. English Rating Enter the 4digits passwordUse the ADJ D or E button to highlight the Can. English Rating and press the OK Enter buttonCanadian French Ratings E Expect No restriction. G For all Use the ADJ D or E button to highlight the Can. FrenchOptions for Can. French Rating Dim3 and press the OK Enter button Will be available only for digital channel signalThis function operates only when TV has received Use the ADJ D or E button to highlight the D/L RatingPress OK Enter button When finished, press Menu repeatedly to removeCaption Menu To highlight the Caption menu and press the OK EnterUse the ADJ D E F G buttons to customize each option Font Use the ADJ D or E button to highlight Digital ModeUse the ADJ D or E button to choose Service 1-Service Customize the digital captions that appear on your screenG E 4 Sound MenuUse the ADJ D or E button to highlight Digital Output Use the ADJ D / E buttons to choose Dolby Digital or PCMUse the ADJ D or E button to choose Mono, Stereo or SAP Use the ADJ D or E button to highlight Auto VolumeTo highlight the Sound menu and press the OK Enter French and press the OK Enter button Use the ADJ D or E button to choose English, Spanish orUse the ADJ D or E button to highlight Menu Language Language ControlUse the ADJ D or E button to highlight and set the Menu Language English, Español or FrançaisUse the ADJ D or E button to choose 1-99 numbers and press Set IDPicture Menu Color Temperature and press the OK Enter buttonUse the ADJ D or E button to choose Screen Format Buttons to set your own settings for the options. WhenUse the ADJ D or E button to choose a preset screen Finished, press the Menu buttonUse the ADJ D or E button to choose Noise Reduction Use the ADJ D or E button to choose Film Mode and pressTypical Installer Menu Commercial Mode Setup If batteries are removed, the Clone Clock time will be lost Cloning Connections/Learning SetupTurn to the next page to continue Cloning Setup G E 5Set the Clock Optional Clone Programmer Learning SetupLearn Setup from Master TV/STB Disconnect TV/STB Power for 15 Seconds Cloning Connections / Teaching SetupTeach Master TV/STB’s Setup to the target Installer Menu Items 000 through Installer MenuAccessing the Installer’s Menu Using the Installer’s MenuInstaller Menu Items 035 through Installer Sequence Detailed Descriptions of Installer Menu ItemsPoll Rate Mute DisableSleep Timer Caption LockRJP Available AUX StatusVID OUT Format Atsc Tune ModeAtsc Band Start Minor ChannelFilm Mode Reference TV Features / Menus that can be ClonedChannel Picture Sound Setup Caption Changing Source Labels on Master TV Adding Channel Icons and Labels in the 2-5-4 + Menu ModeTo Do Channel Editing/Labeling, proceed as follows Changing/Adding Channel Labels on Master TVDetailed Instructions Reference Detailed Information For Making a Master TVReference Software Version Check Procedure to Check Software VersionTV/STB Aux Input Configuration TV/STB Aux Input ConfigurationDisplays ‘No Signal’ message at Power Off TV/STB RS-232 Monitor Requirements / RS-232 TroubleshootingType of Connector D-Sub 9-Pin Female Transmission / Receiving Protocol Connecting the cableRS-232C Control Communication ParameterSet ID OKDatax KeyCommand m cTo send IR remote key code Mc Set ID DataCr Data Key code Refer to page A18Troubleshooting Clone Programmer Troubleshooting Reference Cloning Procedure TroubleshootingReset Clone After Static Shock Troubleshooting Flow Chart G E 7 Installer Quick Setup GuideOHM RF Cable Glossary of TermsOWNER’S Responsibility For Customer Support/Service Please callCopyright 2008 LG Electronics U.S.A., Inc LG’S Responsibility