Zenith HCS5610 warranty Monitor Ventilation

Ventilation

The HCS5610 Integrator Box as well as Plasma monitors generate heat during operation and need to be provided with adequate ventilation to assure continued reliable operation. See recommenda- tions below.

Ventilation Clearance

Proper clearance for air to flow around the HCS5610

Integrator Box must be provided.

Monitor Ventilation

Be sure proper ventilation is provided for the monitor, see monitor installation guide for specified ventilation requirements.

1	There are ventilation holes on four sides of the the
	HCS5610 box provided for ventilation cooling.
	a. If the box is mounted vertically, the vents on the
	sides should be located on the top and bottom for
	free vertical air movement.
	b. If the box is mounted horizontally, the vents should
	be located at the sides and top of the enclosure
	(never mount the box with vents facing down). See
	drawings to the right for reference.
2	The vent holes should never be blocked or obstructed to
	airflow but have an unimpeded path through any enclo-
	sure back to room temperature air.
3	The unit and its venting, should not be installed near
	heat sources such as radiators or heating ducts.
4	If the unit is placed in an enclosure, tests should be run
	to confirm that the ambient temperature around the unit
	under normal expected operating conditions is stable and
	does not exceed 40 degrees Celsius (104F). This can be
	determined by placing a thermometer near the air intake
	vents in the proposed enclosure and measuring the
	temperature every hour, under normal operating
	conditions, until two successive readings repeat.
	If temperature does not stabilize but keeps increasing
	above 104F, ventilation is inadequate and needs to be
	improved.
5	Always provide adequate air space between the ventila-
	tion areas and adjacent structures.
	*Note:
	In addition to the ventilation requirements shown, be sure to
	allow enough clearance (4” - 5”) for wiring clusters attached to
	the Integrator Box.

Vent Holes

Vent Holes

Vent Holes

Vent Holes

Vent Holes

Vent Holes

P A G E 8