AMX AXB-TCR manual J3 jumper settings IR attenuation mode bypass or adjustment

Installation and Wiring

JI jumper settings: TV power sensing/TV power current sensing mode

JI Jumper Settings: TV Power Sensing/TV Power Current Sensing

Television Power Sensing mode	To use this mode, connect a TVS TV Sensor
	to the television to detect horizontal scan fre-
	quencies up to 65 kHz.
	Place the 2-pin jumper on the JP1 connector
	pin's 1 and 2.
Television Power Current Sensing mode	To use this mode, connect a sensor device
	(such as a PCS2 Dual Power Current Sen-
	sor or VSS2 Video Sync Sensor) to the
	television to detect on and off power status.
	Place the 2-pin jumper on the JP1 connector
	pin's 2 and 3.

J2 jumper settings: IR output mode (IR or serial communication)

J2 Jumper Settings: IR Output Mode (IR or Serial Communication)

IR Output mode	To use this mode, connect a CC-IRC IR
	Emitter to the television to transmit IR sig-
	nals.
	Place the 2-pin jumper on the JP2 connector
	pin's 2 and 3.
Serial (wired connection) Output mode	Place the 2-pin jumper on the JP2 connector
	pin's 1 and 2.

J3 jumper settings: IR attenuation mode (bypass or adjustment)

J3 Jumper Settings: IR Attenuation Mode (Bypass or Adjustment)

IR Signal Attenuation Bypass mode (normal)	Place the 2-pin jumper on the JP3 connector
	pin's 1 and 2.
IR Signal Attenuation Adjustment mode	Place the 2-pin jumper on the JP3 connector
	pin's 2 and 3.
	Also, set the JP2 internal jumper for IR emit-
	ter mode.

Refer to the product documentation for the PCS2 Dual Power Current Sensor, VSS2

Video Sync Sensor, TVS TV Sensor and CC-IRC IR Emitter (available online at

www.amx.com) for more information on these devices.

6 AXB-TC and AXB-TCR Television Controllers (& Receivers)