AMX AXB-TCR manual Channel Setting Commands

Page 19

Programming Information

Programming Information

Overview

The television controllers are controlled with channel settings, IR functions, and Axcess

Send_Commands. You create software programs with the AMX Axcess programming software. Use the programming information in this section with the Axcess Programming Guide to program television controllers. After you create the IRLIB program, download it to the non-volatile (battery protected) memory in the television controller. Refer to the IRLIB Infrared Library Management Program instruction manual to create and store IR control files.

Channel Setting Commands

Use the channel setting commands listed in the following table to generate IR code, PUSH and RELEASE operations, and to detect power failure errors.

Channel Setting Commands

Chann	Description
el

1-127	Channels that generate IR code for the corresponding functions.

128-247	PUSH and RELEASE channels for received IR code.

248A PUSH on this channel generates a power failure error.

249Red IR sensor (AXB-TCR only) LED blinks when channel 249 and 250 are on.

250Red IR sensor (AXB-TCR only) LED lights when channel is on.

255Channel is on, when the television power sensor (CC-IR) detects a horizontal scan frequency. The channel is disabled after the television controller receives a 'POF' (power off) or 'PON' (power on) command. The channel is enabled after the television controller receives a 'POD' (disable 'PON' or 'POF') command.

If one of these channels is turned on while another is already on, the initial channel stops transmitting and the second channel begins.

AXB-TC and AXB-TCR Television Controllers (& Receivers)	15

Image 19

Contents AXB-TC and AXB-TCR AMX Limited Warranty and Disclaimer Table of Contents AXB-TC and AXB-TCR Television Controllers & Receivers Overview AXB-TC and AXB-TCR Television ControllersAXB-TC/TCR Specifications SpecificationsAXB-TC AXB-TCR ApplicationsAXB-TC and AXB-TCR Television Controllers Internal Jumper Settings Setting the Device DIP SwitchDIP Switch Settings J3 Jumper Settings IR Attenuation Mode Bypass or Adjustment J3 jumper settings IR attenuation mode bypass or adjustmentTV Sensor connections WiringWiring guidelines Preparing/connecting captive wiresAxlink data and 12 VDC power supply connections Axlink data and power connectionsIR Emitter connections PCS and 12 VDC power supply connections PCS and Axlink data and power connectionsSE-TC mounting dimensions InstallationIR Signal Attenuation Adjustment Television Power Sensor AdjustmentLithium battery and socket Replacing the Lithium BatteryInstallation and Wiring Installation and Wiring Channel Setting Commands Channel Setting CommandsIR Functions Standard Order IR Functions Standard OrderSendCommands SendCommands?CTON ?PTOF XCH Channel Using Softrom Firmware UpgradesUsing NetLinx Studio Upon completion of the upgrade, press F10 to exit SoftromProgramming Information It’s Your World Take Control