AMX AXB-TCR manual IR Emitter connections, Axlink data and power connections

Page 12

Installation and Wiring

IR Emitter connections

Connect the CC-IRC IR Emitter to the IR Emitter connector, on the rear panel of the television controller (FIG. 3) to transmit IR control signals to the television.

CC-IRC

Television

IR EMITTER

GND

connector

SG

 

FIG. 3 CC-IRC IR Emitter connector wiring diagram

Axlink data and power connections

Connect the Central Controllers's AXlink connector to the AXlink connector on the rear panel of the television controller for data and 12 VDC power, as shown in FIG. 4.

12 VDC PWR connector

PWR

GND

PWR

AXP

AXlink connector

AXM

GND

no connection

PWR

AXP

Axcess Control System

AXM

GND

FIG. 4 AXlink data and power wiring diagram

Axlink data and 12 VDC power supply connections

Connect the Central Controller’s AXlink connector to the AXlink connector on the rear panel of the television controller, and the optional 12 VDC power supply, as shown in FIG. 5.

12 VDC PWR connector

PWR

GND

PWR

AXP

AXlink connector

AXM

GND

12 VDC power supply

PWR

AXP

Axcess Control System

AXM

GND

FIG. 5 AXlink Data and 12 VDC Power Supply Connections

Use the 12 VDC power supply when the distance between the AMX system and television controller exceeds the limits described in the Wiring Guidelines table on page 7.

8

AXB-TC and AXB-TCR Television Controllers (& Receivers)

Page 11 Page 13
Image 12
Page 11 Page 13
Contents AXB-TC and AXB-TCR AMX Limited Warranty and Disclaimer Table of Contents AXB-TC and AXB-TCR Television Controllers & Receivers AXB-TC and AXB-TCR Television Controllers OverviewSpecifications AXB-TC/TCR SpecificationsApplications AXB-TC AXB-TCRAXB-TC and AXB-TCR Television Controllers Setting the Device DIP Switch Internal Jumper SettingsDIP Switch Settings J3 jumper settings IR attenuation mode bypass or adjustment J3 Jumper Settings IR Attenuation Mode Bypass or AdjustmentWiring Wiring guidelinesPreparing/connecting captive wires TV Sensor connectionsAxlink data and power connections Axlink data and 12 VDC power supply connectionsIR Emitter connections PCS and Axlink data and power connections PCS and 12 VDC power supply connectionsInstallation SE-TC mounting dimensionsTelevision Power Sensor Adjustment IR Signal Attenuation AdjustmentReplacing the Lithium Battery Lithium battery and socketInstallation and Wiring Installation and Wiring Channel Setting Commands Channel Setting CommandsIR Functions Standard Order IR Functions Standard OrderSendCommands SendCommands?CTON ?PTOF XCH Channel Firmware Upgrades Using SoftromUpon completion of the upgrade, press F10 to exit Softrom Using NetLinx StudioProgramming Information It’s Your World Take Control
Top Page Image Contents