Installation and Wiring
4.Turn the POT screw clockwise
5.Send an IR control signal to the television for all programmed operations. If an operation fails, go back to step 4.
6.Reattach the enclosure and refasten the two screws.
Replacing the Lithium Battery
There is a lithium battery (FIG. 10), with a life of approximately five years, in the television controller that protects stored presets if there is a power loss. The battery is not used when DC power is supplied to the television controller. You should write down the replacement date on a sticker or label by adding 5 years to the date of installation, and attach it to the bottom of the television controller.
Battery (CR2025 type)
socket
FIG. 10 Lithium battery and socket
All control commands in television controller memory are lost when the lithium battery is replaced.
Contact your AMX dealer before you replace the lithium battery to verify that they have a current copy of the IRLIB program file for your television controller. This will prevent any inadvertent loss of data or service outage.
Static electricity can damage electronic circuitry. Before removing the battery from the enclosure, discharge any static electricity from your body by touching a grounded metal object.
Use a
1.Discharge the static electricity from your body.
2.Unplug all cables from the television controller.
3.Remove the two
4.Pull the two enclosure halves apart and set the bottom portion of the enclosure on a flat surface.
5.Locate the battery on the circuit card.
6.Carefully pry the battery out of its socket and insert the new battery. Write down the next replacement date on a label by adding 5 years to the replacement date; attach it to the bottom of the television controller.
7.Reattach the enclosure and refasten the two screws.
8.Plug all cables back into the television controllers.
12 |
|