AMX AXB-TCR manual Installation, SE-TC mounting dimensions

Page 14

Installation and Wiring

Installation

Install the television controller on any flat surface or inside the optional SE-TC Security Enclosure, as described below:

1.Mount the Axcess Central Controller where it will be used. Then, connect the power supply.

2.Route the Axlink power and data cable, CC-IR TV Sensor cable, CC-IRC IR Emitter cable, and 12 VDC power supply from the television to the television controller's location.

3.Drill four #6-32 holes into the SE-TC mounting surface in the locations shown in FIG. 8.

FIG. 8 SE-TC mounting dimensions

4.Mount the SE-TC.

10	AXB-TC and AXB-TCR Television Controllers (& Receivers)

Image 14

Contents AXB-TC and AXB-TCR AMX Limited Warranty and Disclaimer Table of Contents AXB-TC and AXB-TCR Television Controllers & Receivers AXB-TC and AXB-TCR Television Controllers OverviewSpecifications AXB-TC/TCR SpecificationsApplications AXB-TC AXB-TCRAXB-TC and AXB-TCR Television Controllers DIP Switch Settings Setting the Device DIP SwitchInternal Jumper Settings J3 jumper settings IR attenuation mode bypass or adjustment J3 Jumper Settings IR Attenuation Mode Bypass or AdjustmentPreparing/connecting captive wires WiringWiring guidelines TV Sensor connectionsIR Emitter connections Axlink data and power connectionsAxlink data and 12 VDC power supply connections PCS and Axlink data and power connections PCS and 12 VDC power supply connectionsInstallation SE-TC mounting dimensionsTelevision Power Sensor Adjustment IR Signal Attenuation AdjustmentReplacing the Lithium Battery Lithium battery and socketInstallation and Wiring Installation and Wiring Channel Setting Commands Channel Setting CommandsIR Functions Standard Order IR Functions Standard OrderSendCommands SendCommands?CTON ?PTOF XCH Channel Firmware Upgrades Using SoftromUpon completion of the upgrade, press F10 to exit Softrom Using NetLinx StudioProgramming Information It’s Your World Take Control