Pelco Speed Dome

DVR-16/IP is capable of connecting to PELCO Speed Dome; the related settings can be adjusted here in this sub-menu. You can pan/ tilt PELCO Speed Dome by pressing SET and the direction buttons simultaneously after you are entering this sub-menu.

Protocol Setup

	PELCO Speed Dome
1	Protocol Setup	D_Type
2	ID Setup	1

3Zoom

4Focus

5Bfightness

6Set Preset Point

7Goto Preset Point

8Enter Speed Dome Menu

9Exit

There are two Protocol types to choose from: D_type and P_type.

ID Setup

Each PELCO dome camera should have a ID individually.

Zoom

Press the right direction to zoom in (tele) and the left direction button to zoom out (wide). Press ESC to exit the zoom mode.

Focus

Press the right/ left direction to change focus back and forth between a near object and a far object. Press ESC to exit the mode.

Brightness

Use the right and left direction buttons to adjust to appropriate brightness. Press ESC to exit when you finish the setting.

Set Preset Point

This item allows you to set preset points through the front panel. Pan/ tilt the connected receiver to a proper position, and then press the number buttons to assign a number to the preset point. Press Enter to finish the setting.

Goto Preset Point

Press right/ left direction button to select the number of the wanted preset point; then press Enter to go to the selected preset point.

Enter Speed Dome Menu

Press Enter on this item to enter connected PELCO dome camera’s OSD menu. The function only supports a dome camera with DSCP protocol.

CHIPER CRT.V9KRP

This sub-menu allows you to set the receiver. In the sub-menu, you can pan/ tile the receiver by pressing SET and direction buttons simultaneously.耟

Item 1~4 (ID Setup, Zoom, Focus, Brightness)

Please refer to the receiver user’s manual for detailed information.

Set Preset Point

CHIPER CRT.V9KRP

1 ID Setup

2Zoom

3Focus

4Brightness

5	Set Preset Point	1
6	Goto Preset Point
7	Set Group Dwell
8	Go Preset Group
9	Stop Preset Group

10 Exit