Speco Technologies DVR-16/IP user manual Precautions

Page 2

Precautions

zAll the safety and operation instructions should be read before the DVR-16/IP is operated.

zAll the safety and operation instructions should be retained for future reference.

zComply with operating instruction and notice warning information.

zDo not use strong or abrasive detergents when cleaning the DVR-16/IP.

zThere are no user-serviceable parts inside. Contact qualified service personnel for maintenance.

zDo not expose the DVR-16/IP to water or moisture and do not try to operate it in wet areas. Well-chosen cover is needed when you put the DVR-16/IP in outdoor areas.

zMake sure that two ends of the power port are plugged.

zDo not drop metallic parts through slots or slop the DVR-16/IP with any liquid.

zDo not attempt to disassemble the DVR-16/IP.

zContact qualified service personnel if the following situation happens:

yThe power-supply cord or plug is damaged.

yThe DVR-16/IP has been exposed to rain or water.

yThe DVR-16/IP does not operate normally by following the operating instructions.

yThe DVR-16/IP falls to the ground or its cover is damaged.

zWhen replacement parts are required, make sure that the service technician has used replacement parts specified by original seller or that these parts have the same characteristics as the original ones. Unauthorized substitutions may result in fire, electric shock, or other hazards.

zUse only with a mounting accessory recommended by original seller.

zNever push objects of any kind into this DVR-16/IP through openings as they may touch dangerous voltage points or short cut parts that could result in a fire or electric shock.

zCertify operating safety by qualified installer.

zIf an outside cable system is connected to the DVR-16/IP, be sure the cable system is grounded so as to provide some protection against voltage surges and built-in static charges.

zAll normal precautions to avoid component damage due to electrostatic discharge should be taken during installation and operation.

zTo prevent electric shock, do not remove screws or covers.

1

Image 2
Contents DVR-16/IP Precautions Content DVR-16/IP Menu Tree OSD Menu SetupPage DVR-16IP Remote Access of Video over the Web Windows Application SoftwareFeatures DVR-16/IP ApplicationQuick Installation Guide Front Panel Introduction Buttons on the Front PanelPages TimerSetup ModeSET DVR-16/IP Menu Tree CD-RWEvent List OSD / Timer Monitor Camera Record Ntsc Event List OSD Menu SetupOSD/ Timer Monitor Camera 1.3 PTZ InstallCovert RS-485 Baud RatePelco Speed Dome Gain Control Alarm REC PriorityTermination REC PriorityCamera Title RecordCamera Detect 1 Day/ Night WeekendREC Event At Switch REC While PBREC Event Only 1 Day/ Night Switch Rec Priority ModeHDD Full Alarm EventEvent Response Motion Detect Video Loss Detect AlarmAlarm Set/ Reset SW Release TimeOthers CD-RW Copy Save/ Load DefaultEngineer Set Up Covert Cam Visible Disable PasswordSuper MMX Mode Playback CheckConnect the USB Mobile Rack to PC Windows Application SoftwareExit Download the Software Function ButtonsFast Rewind PlaybackGo to Begin Rewind PlayingButton Introduction DVR-16IP Remote Access of Video over the WebPreset Pt Zoom In/ Zoom OutStep Degree Direction buttonsMenu/ Enter DVR-16/IP-related buttonsGeneral User Permission PasswordServer UserNetwork Network settingsSystem GET ID Dynamic DNS ConfigurationVideo Rear Board ConnectorsPassword Channel ButtonsExternal I/O Port 37pin Dsub External I/O BoardModel Name SpecificationRS-485 RJ11 Appendix 1 Hard Disk Error Message Appendix 2 Supported HDD Brand Capacity Rotation Speed Part NumberAppendix 3 RS-485 Command Set ExampleAppendix 4 Super MMX & Super MPX System Setup MMX Multiplexer-MatrixSuper MPX Super Multiplexer Mode Camera ID Remark