
Operation Instruction
The DVR can be set to react to system events. System events can be associated with an
Highlight the button. A list of Alarm Outputs appears. You can associate as many
Figure 42 — System Event Actions screen.
NOTE:
Highlight the Notify box beside the desired event (System, Boot Up, Restart, Shutdown, Panic Record, Check Recording, Check button. You can toggle the entire list On and Off by highlighting Notification and pressing the
button. You can toggle the individual items On and Off by highlighting that item and pressing the
button. Highlight OK and press the
button to accept your changes.
NOTE: For the Notify action to work, the DVR should be registered in the Speco Central (Remote Administration System).
Event Status
Highlight Event Status in the Event menu and press the button. The Event Status screen appears.
The Event Status screen displays the status of the DVR’s systems and inputs. Events will be highlighted, and related channels or events will flicker for five seconds when detected.
(Motion),
(Video Loss),
(Video Blind) and
| based on the settings you made in the |
| Detection, Video Loss, Video Blind and |
| on the Event menu. |
| (Check |
| highlighted when each event is detected based on the settings |
| you made in the System Event setup screen on the Event menu. |
Figure 43 — Event Status screen. | Panic Record will be highlighted while the DVR is in the |
| panic recording mode. |
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the level of disk usage reaches the Disk Almost Full percentage you made in the System Event setup screen on the Event menu. Disk Full will be highlighted when the DVR is not in the Recycle mode and all available storage space has been used.
Fan Error will be highlighted when the cooling fan to the left of the power cord on the rear panel is not working for more than four seconds.
Disk Config Change will be highlighted when the DVR reboots after the hard disk drive has been replaced. Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage section for details.
34