Marantz PDxx01 Wiring, Communication Parameters, Connections should be made as described below

Page 4

PDxx01

RS-232C Control Specification

Page: 4 / 49

Document Version [1.0]

1. Application

These specifications are applicable to plasma monitors and communications control from external equipment.

"Please also support the command of VP series and refer to the manual of the conventional model about specification."

2. Connections

Connections should be made as described below.

plasma monitor

External equipment e.g., Personal computer

2-1.Connector on the plasma monitor side: EXTERNAL CONTROL connector.

Type of connector: D-Sub 9-pin male

No.

Pin Name

 

 

1

No Connection

2

RXD (Receive data)

3

TXD (Transmit data)

4

DTR (DTE side ready)

5

GND

6

DSR (DCE side ready)

7

RTS (Ready to send)

8

CTS (Clear to send)

9

No Connection

2-2.Connector on the external equipment side: Serial port (RS-232C) connector.

See the specifications of the equipment that is to be connected for the type of connector and pin assignment.

2-3.Wiring

Use a crossed (reverse) cable.

Wire the cable so that each pair of data lines crosses between the two devices. These data line pairs are RXD (Receive data) and TXD (Transmit data), DTR (DTE side ready) and DSR (DCE side ready), and RTS (Ready to send) and CTS (Clear to send).

2-4.Communication Parameters

(1)

Communication system

Asynchronous

(2)

Interface

RS-232C

(3)

Baud rate

9600 bps

(4)

Data length

8 bits

(5)

Parity

Odd

(6)

Stop bit

1 bit

(7)

Communication code

Hex

Company Restricted

Image 4
Contents PDxx01 RS-232C Control Specification Table of Contents Revision history Communication Parameters WiringConnections should be made as described below Command1 CommandCheck Sum CKS, Error Processing, and ACK Unit ID1,2 UA1,UA2Command Reference List Picture Freeze DFH 7CH Power OFF Power onInput Switch Change Audio Mute on Volume Gain DataAudio Mute OFF Contrast Gain Data Bright Gain DataSharpness Gain Data Color Gain DataPicture Mode Select Tint Gain DataDFH 80H 60H 0AH 01H DATA00 CKS 7FH 60H 80H 0AH 01H DATA00 CKSColor Temp Select RED Gain DataDFH 80H 60H 00H 01H DATA00 CKS 7FH 60H 80H 00H 01H DATA00 CKSGreen Gain Data Blue Gain DataNR Mode Set Bass Gain DataDFH 80H 60H C0H 01H DATA00 CKS 7FH 60H 80H C0H 01H DATA00 CKSTreble Gain Data Balance Gain DataScreen Mode Select 22.V. Position Gain DataDFH 80H 60H 51H 01H DATA00 CKS 7FH 60H 80H 51H 01H DATA00 CKS24.V. Height Gain Data 23.H. Position Gain Data25.H. Width Gain Data Auto Picture Select Phase Fine Picture Gain Data7FH 60H 80H 7FH 03H DATA00 DATA01 DATA02 CKS Clock Picture Adjust Gain Data Power MGT SelectOSM ADJ. Position Data 7FH 60H 80H 1AH 01H DATA00 CKSGray Level Set Cinema Mode SetLong Life Set PDP Saver Set ALL Reset Screen Wiper SetAudio Select Set DFH 80H 60H 70H 02H DATA00 DATA01 CKSDFH 80H 60H 8BH 01H DATA00 CKS RGB Select7FH 60H 80H 8BH 01H DATA00 CKS Vmode:7 @70 @72 Mode:10 1024×768 1152×864 Mode:8 @75 HD Select Language SelectFrequency Request Signal Information Color System Select01H to 80H RGB signal 81H58NTSC 82H 43NTSC 83H 84HInput Mode Request Video ADJ. RequestPDxx01 RS-232C Control Specification Document Version 1FH 80H 60H 6FH 00H CKS Audio Select Request7FH 60H 80H 6FH 03H DATA00 DATA01 DATA02 CKS 1FH 80H 60H 3FH 00H CKS Failure Mode Request7FH 60H 80H 3FH 02H DATA00 DATA01 CKS 1FH 80H 60H 17H 00H CKS Model Name Request7FH 60H 80H 17H 0CH DATA00 to DATA11 CKS LOW Tone 50inch only Color TuneDFH 80H 60H 0CH 01H DATA00 CKS 7FH 60H 80H 0CH 01H DATA00 CKSGamma Gain Data Running SenseInput Skip OSM OrbiterSerial No. Request Soft Focus 54.S1/S2 SelectBlack Level Select Multi Sprit Screen Select DFH 80H 60H 07H 01H DATA00 CKSSUB Picture Detect Select 7FH 60H 80H 07H 01H DATA00 CKSDFH 80H 60H 7AH 01H DATA00 CKS 7FH 60H 80H 7AH 01H DATA00 CKSZoom Navigation Select Picture Freeze SelectDFH 80H 60H 7BH 01H DATA00 CKS DFH 80H 60H 7CH 01H DATA00 CKSOSM Contrast Select Picture Freeze Pause CommandCC Closed caption Select CC Closed caption Contrast Select Picture Memory SelectPicture Memory Note Write Set Picture Memory SetDFH 80H 60H 25H 02H DATA00 DATA01 CKS SET UP Level Select Back Ground SelectPDP Saver Auto Select Power on Mode InputAudio Hdmi Request Power on Mode Volume SUB Picture Rate setDFH 80H 60H 0FH 01H DATA00 CKS 7FH 60H 80H 0FH 00H CKSDFH 80H 60H 33H 04H DATA00 to DATA03 CKS Multi Sprit Screen Power on Mode SET7FH 0H 80H 33H 00H CKS Volume Gain Data Request Remote Code SettingUnder Scan Setting Revision history