KTI Networks KSC-240 manual Installation, Unpacking

Page 12

2. Installation

2.1 Unpacking

Check that the following components have been included:

•Information CD

•The device unit

•DIN-rail mounting bracket

If any item is found missing or damaged, please contact your local reseller for replacement.

The following are available optional accessories:

•Panel Mounting Bracket

The bracket is used for mounting the device on a panel surface.

•Commercial-rated AC power adapters:

-Rated AC120V/60Hz DC7.5V 1A

-Rated AC230V/50Hz DC7.5V 1A

-Rated AC100V/50-60Hz DC7.5V 1A

-Rated AC240V/50Hz DC7.5V 1A

The adapters are used for supplying DC power to the converter via DC power jack interface.

-12-

Image 12

Contents KSC-240 Installation Guide Industrial RS-232 to RS-485/422 ConverterUnited States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications LEDIndicators Serial Interface RS-232 PortRS-485/422 Interface Configuration DIP SW Settings Name State FunctionDC Power Interface Basic InformationMechanical EnvironmentalCertificate CE/EMCInstallation UnpackingSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Applying Power Using Terminal BlocksPage UsingDC Power Jack Power Failure Relay Output DIP SW Configuration SW1-2SW1-3 SW1-4 TXESW1-5 SW1-6SW1-8&7 SW2-1 SW2-2SW2-3 SW2-41 RS-485/422 Driver and Receiver Control SW1-4 SW1-6 SW1-5 SW2-1 BehaviorMaking Serial RS-232 Connection Typical RS-232 Interface DCE Pin Assignment TableSignal Name Input/Output Cable for Connection to PC COM Port Characteristics RS-422 RS-485 Making RS-485/422 ConnectionRS-422 Point-to-Point Circuit RS-422 Multi-drop Network TXE RS-485 Multi-drop Network TXC RS-485 Half-duplex 2-wire Network RS-485 Full-duplex 4-wire Network Or use ADC control optional Summary of the Converter Applications LED Indicators Factory Default Configuration Name Default Setting