KTI Networks KSC-240 manual UsingDC Power Jack

Page 20

UsingDC Power Jack

DC Jack Connector: JackD6.3mmD2.0mm

AC Power Adapters: Optional commercial rated adapters are available for purchasing.

Rated AC120V/60Hz DC7.5V 1A

Rated AC230V/50Hz DC7.5V 1A

Rated AC100V/50-60Hz DC7.5V 1A

Rated AC240V/50Hz DC7.5V 1A

Connect power adapter DC plug to the DC power jack of the converter before connecting to the AC outlet. Connect the power adapter to the AC outlet.

Note: Before you begin the installation, check the AC voltage of your area. The AC power adapter which is used to supply the DC power for the unit should have the AC voltage matching the commercial power voltage in your area.

-20-

Image 20

Contents KSC-240 Installation Guide Industrial RS-232 to RS-485/422 ConverterUnited States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications RS-485/422 Interface LEDIndicatorsSerial Interface RS-232 Port Configuration DIP SW Settings Name State FunctionDC Power Interface Basic InformationMechanical EnvironmentalCertificate CE/EMCInstallation UnpackingSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Applying Power Using Terminal BlocksPage UsingDC Power Jack Power Failure Relay Output DIP SW Configuration SW1-2SW1-3 SW1-4 TXESW1-5 SW1-6SW1-8&7 SW2-1 SW2-2SW2-3 SW2-41 RS-485/422 Driver and Receiver Control SW1-4 SW1-6 SW1-5 SW2-1 BehaviorMaking Serial RS-232 Connection Typical RS-232 Interface DCE Pin Assignment TableSignal Name Input/Output Cable for Connection to PC COM Port Characteristics RS-422 RS-485 Making RS-485/422 ConnectionRS-422 Point-to-Point Circuit RS-422 Multi-drop Network TXE RS-485 Multi-drop Network TXC RS-485 Half-duplex 2-wire Network RS-485 Full-duplex 4-wire Network Or use ADC control optional Summary of the Converter Applications LED Indicators Factory Default Configuration Name Default Setting