KTI Networks KSC-240 manual United States, International

Page 2

(C)2006 KTI Networks Inc. All rights reserved. No part of this documen- tation may be reproduced in any form or by any means or used to make any directive work (such as translation or transformation) without per- mission from KTI Networks Inc.

KTI Networks Inc. reserves the right to revise this documentation and to make changes in content from time to time without obligation on the part of KTI Networks Inc. to provide notification of such revision or change.

For more information, contact:

United States

KTI Networks Inc.

 

P.O. BOX 631008

 

Houston, Texas 77263-1008

 

Phone:

713-2663891

 

Fax:

713-2663893

 

E-mail:

kti@ktinet.com

 

URL:

http://www.ktinet.com/

International

Fax:

886-2-26983873

 

E-mail:

kti@ktinet.com.tw

 

URL:

http://www.ktinet.com.tw/

Image 2
Contents KSC-240 Installation Guide Industrial RS-232 to RS-485/422 ConverterUnited States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications RS-485/422 Interface LEDIndicatorsSerial Interface RS-232 Port Configuration DIP SW Settings Name State FunctionMechanical DC Power InterfaceBasic Information EnvironmentalCertificate CE/EMCInstallation UnpackingSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Applying Power Using Terminal BlocksPage UsingDC Power Jack Power Failure Relay Output DIP SW Configuration SW1-2SW1-3 SW1-4 TXESW1-5 SW1-6SW1-8&7 SW2-3 SW2-1SW2-2 SW2-41 RS-485/422 Driver and Receiver Control SW1-4 SW1-6 SW1-5 SW2-1 BehaviorMaking Serial RS-232 Connection Typical RS-232 Interface DCE Pin Assignment TableSignal Name Input/Output Cable for Connection to PC COM Port Characteristics RS-422 RS-485 Making RS-485/422 ConnectionRS-422 Point-to-Point Circuit RS-422 Multi-drop Network TXE RS-485 Multi-drop Network TXC RS-485 Half-duplex 2-wire Network RS-485 Full-duplex 4-wire Network Or use ADC control optional Summary of the Converter Applications LED Indicators Factory Default Configuration Name Default Setting