KTI Networks KSC-240 manual Txc

Page 37

It is also able to convert an RS-232 device into a SLAVE node in this multi- drop network.

The configuration for a SLAVE node is:

SW1-4	TXC	Enable RTS/ADC Control for Driver
SW1-6	RXE	Enable Receiver always
SW1-5	RTS-D	Disable RTS control
SW2-1	SDD	Disable ADC control

-37-

Image 37

Contents Industrial RS-232 to RS-485/422 Converter KSC-240 Installation GuideInternational United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications Serial Interface RS-232 Port LEDIndicatorsRS-485/422 Interface Name State Function Configuration DIP SW SettingsBasic Information DC Power InterfaceMechanical EnvironmentalCE/EMC CertificateUnpacking InstallationSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Using Terminal Blocks Applying PowerPage UsingDC Power Jack Power Failure Relay Output SW1-2 DIP SW ConfigurationSW1-3 TXE SW1-4SW1-6 SW1-5SW1-8&7 SW2-2 SW2-1SW2-3 SW2-4SW1-4 SW1-6 SW1-5 SW2-1 Behavior 1 RS-485/422 Driver and Receiver ControlTypical RS-232 Interface DCE Pin Assignment Table Making Serial RS-232 ConnectionSignal Name Input/Output Cable for Connection to PC COM Port Making RS-485/422 Connection Characteristics RS-422 RS-485RS-422 Point-to-Point Circuit RS-422 Multi-drop Network TXE RS-485 Multi-drop Network TXC RS-485 Half-duplex 2-wire Network RS-485 Full-duplex 4-wire Network Or use ADC control optional Summary of the Converter Applications LED Indicators Name Default Setting Factory Default Configuration