KTI Networks KSC-240 manual SW1-4, Txe

Page 24

SW1-4

TXC	RS-485/422 driver enable control by RTS or ADC
TXE	RS-485/422 driver is forced to enable

[TXC] setting enables RS-485/422 driver to be controlled by RTS method or ADC method. RTS method is described later. Refer to SW2 settings for more description about ADC method.

[TXE] setting forces RS-485/422 driver to be enabled always. This setting is applied when Master function is required in an RS-485/RS-422 multi- drop bus.

-24-

Image 24

Contents KSC-240 Installation Guide Industrial RS-232 to RS-485/422 ConverterUnited States InternationalEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications LEDIndicators Serial Interface RS-232 PortRS-485/422 Interface Configuration DIP SW Settings Name State FunctionDC Power Interface Basic InformationMechanical EnvironmentalCertificate CE/EMCInstallation UnpackingSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Applying Power Using Terminal BlocksPage UsingDC Power Jack Power Failure Relay Output DIP SW Configuration SW1-2SW1-3 SW1-4 TXESW1-5 SW1-6SW1-8&7 SW2-1 SW2-2SW2-3 SW2-41 RS-485/422 Driver and Receiver Control SW1-4 SW1-6 SW1-5 SW2-1 BehaviorMaking Serial RS-232 Connection Typical RS-232 Interface DCE Pin Assignment TableSignal Name Input/Output Cable for Connection to PC COM Port Characteristics RS-422 RS-485 Making RS-485/422 ConnectionRS-422 Point-to-Point Circuit RS-422 Multi-drop Network TXE RS-485 Multi-drop Network TXC RS-485 Half-duplex 2-wire Network RS-485 Full-duplex 4-wire Network Or use ADC control optional Summary of the Converter Applications LED Indicators Factory Default Configuration Name Default Setting