KTI Networks KSC-240 manual Txe

Page 35

The converter can convert an RS-232 device into a Master node in this multi-drop network.

The configuration for MASTER node is:

SW1-4	TXE	Enable Driver always
SW1-6	RXC	Enable Receiver RTS/ADC Control
SW1-5	RTS-D	Disable RTS control
SW2-1	SDD	Disable ADC control

It also can convert an RS-232 device into a SLAVE node in this multi-drop network.

The configuration for a SLAVE node is:

SW1-4	TXC	Enable RTS/ADC Control for Driver
SW1-6	RXE	Enable Receiver always
SW1-5	RTS-D	Disable RTS control
SW2-1	SDD	Disable ADC control

-35-

Image 35

Contents Industrial RS-232 to RS-485/422 Converter KSC-240 Installation GuideInternational United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Features Specifications RS-485/422 Interface LEDIndicatorsSerial Interface RS-232 Port Name State Function Configuration DIP SW SettingsEnvironmental DC Power InterfaceBasic Information MechanicalCE/EMC CertificateUnpacking InstallationSafety Cautions DIN-Rail Mounting Page Panel Mounting Screw locations and final dimension are shown below Using Terminal Blocks Applying PowerPage UsingDC Power Jack Power Failure Relay Output SW1-2 DIP SW ConfigurationSW1-3 TXE SW1-4SW1-6 SW1-5SW1-8&7 SW2-4 SW2-1SW2-2 SW2-3SW1-4 SW1-6 SW1-5 SW2-1 Behavior 1 RS-485/422 Driver and Receiver ControlTypical RS-232 Interface DCE Pin Assignment Table Making Serial RS-232 ConnectionSignal Name Input/Output Cable for Connection to PC COM Port Making RS-485/422 Connection Characteristics RS-422 RS-485RS-422 Point-to-Point Circuit RS-422 Multi-drop Network TXE RS-485 Multi-drop Network TXC RS-485 Half-duplex 2-wire Network RS-485 Full-duplex 4-wire Network Or use ADC control optional Summary of the Converter Applications LED Indicators Name Default Setting Factory Default Configuration