Pioneer PRV-LX10 manual System Default Settings, Network, UPS Support

System Default Settings

Network

When using this unit on a network, go to SET UP section = [System] = [Network], and set the [Network] command to “ON”. Then go to SET UP section = [System] = [Network], and set the [DHCP/Manual] command either to use DHCP (Dynamic Host Configuration Protocol) or input the IP address used, together with sub-net mask and Gateway address.

If “DHCP” is selected, confirm that a DHCP server in fact exists. If no server exists, a longer time will be required for the unit to boot to the idling condition when the power is turned on. When “DHCP” is

selected, the [IP Address] command will display the address automatically allocated to the recorder. Also, setting [Network] to “ON” makes it possible to check the MAC address of this unit.

Note:

Be very careful when setting IP address, sub-net mask, and Gateway addresses. Failure to set the correct values may not only make it impossible to connect to a network, but cause malfunctions throughout the network. If you are unsure of the proper values to set for these items, consult your network administrator.

	UPS Support
	Whenever the power to this unit is turned OFF, the
	unit performs a shutdown operation. An unintentional
	power interruption results in the power being
	disconnected without the shutdown operation being
	performed, thus resulting in potential malfunctions. In
	order to avoid such malfunctions, the use of an
	uninterrupted power supply (UPS) is recommended.
	By going to SET UP section = [System] = [UPS
	Setting] = [Model], you can select APC Smart-
	UPS 750 or Smart-UPS 500 (Note).
	Note:
SET UP section = [System] = [Network]	Smart-UPS 500 is for use in Japan only.
	Also, if power is interrupted and the UPS operates,
	the time before automatic shutdown is initiated can
	be set to 30 seconds or 60 seconds (SET UP section
	= [System] = [UPS Setting] = [Shutdown
	Delay]). In this way, the shutdown operation will be
	avoided if normal power is restored within the
	selected time interval.

SET UP section = [System] = [Network] = [DHCP/Manual] = [DHCP]

SET UP section = [System] = [UPS Setting]

	Use the UPS products below, manufactured by
	AMERICAN POWER CONVERSION CORP. (APC).
	Smart-UPS 750VA
	(Part Number: SU750INET)
SET UP section = [System] = [Network] =	Connection of other manufacturers’ UPS will not
	result in proper operation.
[DHCP/Manual] = [Manual]

30

PRV-LX10 En