Panasonic TU-HDS20 manual Rear Panel, CH3/CH4 Switch, YP BP R / RGB Jacks, RGB/YP BP R Switch

FRONT AND REAR VIEW OF THE HDTV DIGITAL RECEIVER

Rear Panel

SATELLITE IN jack CH3/CH4 Switch RF Out jack DIGITAL OUTPUTS NTSC OUTPUTS

SATELLITE	RF OUT
IN	3
ANT IN
	CH 4
MODEL NO.
SERIAL NO.
AC 120V60Hz
MAX AMPS
MANUFACTURED

RGB/YPBPR

					®
				HDTV DIGITAL RECEIVER
	PR	PB	Y	WARNING	!
R-AUDIO-L	R	B	G	RISK OF ELECTRIC SHOCK
				DO NOT OPEN

				DISTRIBUTED BY
				MATSUSHITA ELECTRIC
				CORPORATION OF AMERICA
H-	-L	R-AUDIO-L VIDEO S-VIDEO	DIGITAL	ONE PANASONIC WAY,
				SECAUCUS, NEW JERSEY 07094
DIGITAL		NTSC OUTPUT	AUDIO OUT TEL LINE	ASSEMBLED IN MEXICO
			(AC-3)

ANT IN jack		Modem jack
RGB/YPBPR Switch	H, V jacks	AC-3 / PCM Output
		jack

ANT IN	Use to connect an off-air antenna or cable TV signal to the
	HDTV Digital receiver.
SATELLITE IN	Use to connect DIRECTV satellite signal to the HDTV Digital
	Receiver.
RF OUT	Use to connect the HDTV Digital Receiver to your TV.
CH3/CH4 Switch	If a coaxial cable is used to connect the digital receiver to
	your TV, you must set the CH3/CH4 switch to either CH3 or
	CH4.
YPBPR / RGB Jacks	Primary jacks used to connect the HDTV Digital Receiver to a
	DTV Compatible Television.
RGB/YPBPR Switch	Selects either RGB or Component video (Y,PB,PR) signals
	according to your TV/Monitor.
DIGITAL OUTPUTS	Outputs either Component Video or RGB signal .
NTSC OUTPUTS	Use to connect the HDTV Digital Receiver to a Conventional
	TV.
H, V jacks	Horizontal and Vertical sync jacks used with RGB for high-
	end monitors, video projectors etc..
AC 3/PCM OUTPUT	Use to connect your HDTV Digital Receiver to a Dolby Digital
	AC-3 receiver or decoder.
MODEM	Use to connect a phone line to the HDTV Digital Receiver to
	enable DIRECTV pay per view services.

13