Programming the Remote Control

PROGRAMMING THE REMOTE CONTROL

The Universal Remote Control can be programmed to operate many manufacturers’ components using the component function buttons for VCR, DVD, AUX (RCVR, CD, TAPE, CASSETTE DECK and LD), CBL, DTV, TV, or DBS. Follow the procedures for programming your Remote Control with and without codes for the component. Determine the manufacturer of the component and look in the table for the code.

Note: Be careful to press ACTION in the middle of the button. If you do not press in the middle of the button, the arrow buttons may be activated. This will interrupt your programming.

Programming With Code

•Confirm that the external component is plugged in and is turned on.

•Turn the component off.

•Press the ACTION and POWER button, together, for at least 5 seconds. All mode buttons will flash, then let go of the buttons.

•Press appropriate component button (VCR, CBL, etc.) on the Remote Control. The pressed button will illuminate steadily. All other buttons will go out.

•Enter the 3-digit component code using the Remote Control numeric keypad (0 ~ 9 buttons). If a proper code was entered, the mode button will blink twice and go out.

•Press the Remote Control POWER button to test the component. If the procedure was successful, the component will turn on.

Programming Without Code

Unsuccessful Code

If the component does not operate with the Remote Control, repeat the procedure using another code. (Some brands have multiple codes.)

If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the programming will fail.

This procedure searches all codes and is called the “sequence method”.

•Confirm that the external component is plugged in and is turned on.

•Turn the component off.

•Press the ACTION and POWER button, together, for at least 5 seconds. All mode buttons will flash, then let go of the button.

•Press appropriate component button on the Remote Control. The pressed button will illuminate. All other buttons will go out.

•Press the button to move forward to the next code. Press the button to move backward.

•Press the Remote Control POWER button to test the component. If the

procedure was successful, the component will turn on.

Note: Repeat the preceding two steps until the component code is found. It may take many attempts before the correct code is found.

•After the code is found, press the ACTION button to store the code.