Panasonic TU-HDS20 manual Digital TV/Cable Reception with Conventional TV, Hdtv Digital Receiver

GETTING STARTED

Step 3c. Digital TV/Cable Reception with Conventional TV

Follow this diagram if you have a conventional TV, cable service and terrestrial antenna.

Incoming Cable signal

ANT

IN

ANT

OUT

CABLE BOX

NOTE: ANTENNA, A/B SWITCH, RF

CABLES, CABLE BOX, VIDEO AND

S-VIDEO CABLES NOT INCLUDED.

CONVENTIONAL TV or MONITOR

A/B

SWITCH

AUDIO

RL VIDEO S -VIDEO

INPUT

ANT IN

HDTV DIGITAL RECEIVER

SATELLITE	RF OUT
IN	CH3
ANT IN
	CH4
MODELNO.
SERIALNO.
AC 120V 60Hz
MAXAMPS
MANUFACTURED

RGB/YPBPR

	R
R-AUDIO-L
H-SYNC-L	R-AUDIO-L VIDEO S-VIDEO
DIGITAL OUTPUT	NTSC OUTPUT

	®
HDTV DIGITAL RECEIVER
WARNING	!
RISK OF ELECTRIC SHOCK
DO NOT OPEN

		DISTRIBUTED BY
		MATSUSHITA ELECTRIC
		CORPORATION OF AMERICA
		ONE PANASONIC WAY,
DIGITAL		SECAUCUS, NEW JERSEY 07094
AUDIO OUT TEL LINE	ASSEMBLED IN MEXICO
(AC-3)

DIGITAL TV/CABLE RECEPTION WITH CONVENTIONAL TV (CABLE

SERVICE AND TERRESTRIAL ANTENNA)

Procedure

•Select 480i by using the Video Out button on the front of the HDTV Digital Receiver.

•Connect the antenna cable to one of the inputs (A or B) of the A/B switch.

•If using a cable box, connect the cable wire from the wall jack to the cable box ANT (antenna) IN jack using a standard RF cable with coaxial connector and connect the cable box ANT (antenna) OUT jack to the other input (A or B) of the A/B switch.

•If not using a cable box, connect the cable wire from the wall jack to the second input of the A/B switch using an RF cable (not shown).

•Connect the OUT signal of the A/B switch to the ANT IN jack of the HDTV Digital Receiver.

•Connect the RF OUT jack to the Conventional TV or Monitor by suing a RF cable.

•Connect the NTSC OUTPUTS of the digital receiver to the A/V inputs of the television or monitor.

34