■Rear View
i o!0
IN
OUT
9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 |
9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 |
|
|
|
| VIDEO |
|
|
|
1
SIGNAL
ALARM/REMOTEDATA CAMERA GND
SW IN
1
MULTI |
|
PLAY IN REC OUT SCREEN OUT | SPOT OUT |
u !1
<WJ-FS316/FS416>
i o!0
IN
OUT
16 | 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 |
16 | 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 |
|
|
|
|
|
|
|
| VIDEO |
|
|
|
|
|
|
1
SIGNAL
ALARM/REMOTEDATA CAMERA GND
SW IN
1
MULTI |
|
PLAY IN REC OUT SCREEN OUT | SPOT OUT |
u !1
q Video Input Connectors (VIDEO IN) | y Multiscreen Output Connector (MULTISCREEN OUT) |
These connectors accept a composite video signal | The video output signal for the multiscreen monitor is |
from a camera. | provided via this connector. |
Note: If the input signals have a high jitter content, as in |
|
the case of a VCR playback picture, it may not be | u Spot Output Connector (SPOT OUT) |
possible to synchronize this unit. | Provides the video output signal for the spot monitor. |
w Video Output Connectors (VIDEO OUT) | i Data Port (DATA) |
The video signals connected to the Video Input Connectors (VIDEO IN) are looped through to these connectors with an automatic 75 Ω termination.
eAlarm/Remote Control Connector (ALARM/
REMOTE)
This connector accepts the alarm signals from the associated alarm sensor units and the control signals from the external system.
rPlayback Input Connector (PLAY IN)
The playback signal from the time lapse VCR is sup- plied to this connector.
tRecord Output Connector (REC OUT)
For exchange control data with the
oCamera Switching Input Connector
(CAMERA SW IN)
The camera switching pulse from the time lapse VCR is supplied to this connector.
The camera switching interval (Sequential Dwell Time) can be synchronized with the time lapse mode set in the associated time lapse VCR.
!0Signal Ground Terminal (SIGNAL GND)
!1Power Cord
The recording signal for the time lapse VCR is provided via this connector.
8