IINSTALLING YOUR VCR
AUTO INSTALLATION OF A SATELLITE RECEIVER/
CABLE BOX
POINTS 9-13.
9.Select the first available channel on your satellite receiver.
10.Press [
/
], to set SAT CONTROL to ON.
11.Press [
/
], to select INPUT. L2 will be highlighted.
If your Satellite Receiver is connected to the VCR via the AERIAL IN socket, follow the procedure below.
i.Your satellite receiver should be connected to the AERIAL IN socket on the back of the VCR. (Refer to CONNECTING A
SATELLITE RECEIVER/CABLE BOX TO YOUR VCR for connection diagram.)
ii.Select RF IN using [
/
]. You will now need to tune the VCR into the Satellite
Receiver.
iii.Press [
/
]to select CHANNEL on the
iv.Press [
]. The current channel will be displayed as a background to the on-
screen display. If this is not a satellite
channel press [
]again. Continue until you see a satellite channel. By pressing MODE
OSD button, the VCR will change to a blue background. This may help you see which channel your VCR has tuned in.
10.
S A T R E C E I V E R
S A T CON T RO L | ON | O F F |
➔ I N P U T | R F I N L 2 | |
S A T NO . | 0 0 1 |
|
P L E A S E CONN E C T - - - - - |
| |
S A T | L 2 | V CR |
- - - - - - - - - - - |
| |
: S E L E C T | : CHANGE | |
S E T : E N T E R | ME NU : E X I T | |
S A T R E C E I V E R |
| |
S A T CON T RO L | ON | O F F |
I N P U T | R F I N L 2 | |
➔CHANN E L | CH 2 1 |
|
S A T NO . | 0 0 1 |
|
P L E A S E CONN E C T - - - - - |
| |
S A T | L 2 | V CR |
- - - - - - - - - - - |
| |
: S E L E C T | : CHANGE | |
S E T : E N T E R | ME NU : E X I T | |
REMOTE CONTROL
MENU SELECT
BUTTONS
See next page to continue 
www.sharp.co.uk/support
9