CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
•It should not be necessary to tune in a broadcast channel manually except in unusual circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
Ensure the Video channel is selected on the TV.
1.Press the MENU 
button. Press the
[ / ]menu select buttons to select | 2. | ||
SET UP. Press the SET SET | button to | ||
S E T U P | |||
|
| ||
confirm.
2.CHANNEL PRESET will be highlighted. Press the SET SET button to
confirm.
C HANN E L P R E S E T C HANN E L SOR T
C L OCK
P OS T COD E
3.MANUAL TUNING will be highlighted. Press the SET SET button to
confirm.
4.PRESET will be highlighted. Press
the[
/
]menu select buttons to choose the required VCR preset channel.
5.If you have SATELLITE CONTROL set to ON, continue from point 6. Otherwise continue from point 7.
➔P R E S E T
SOURC E
CHANN E L
F I N E T UN I NG D E COD E R
S K I P
BBC 1 | 1 |
CH | S A T |
| CH 2 1 |
ON | ▲ ▲ |
O F F | |
ON | O F F |
6.Press[
/
]to select SOURCE. Then choose the required source:
•If you wish to tune a satellite or cable
channel press [
/
] to select SAT. Then press[
/
]to select CHANNEL. Enter preset satellite
channel using the NUMBER
BUTTONS or by using the [
/
] buttons step through each preset satellite
channel until the desired channel is displayed. Continue from point 10.
•If you wish to tune a terrestrial channel press [
/
] to select CH.
Continue from point 7.
MENU
SET
MENU SELECT
BUTTONS
REMOTE CONTROL
www.sharp.co.uk/support
34