Sharp VC-MH835HM HOW to CHECK, Change and Cancel a Delayed Recording, Press the Timer ON/OFF

TINS-A082UMN1.book Page 21 Monday, November 4, 2002 2:33 PM

BASIC OPERATION

HOW TO CHECK, CHANGE AND CANCEL A DELAYED RECORDING

Before you start!

• If the Timer Standby symbol	appears on the VCR display,
press the TIMER ON/OFF	button to remove the
symbol.

CHECKING A RECORDING

1.Press STOP to switch on the VCR.

2.Press the MENU button.

3.Press[/]to select TIMER. Press the SET SET button to confirm.

•All the delayed recordings in the VCR’s memory will be shown.

4.If the settings are correct press the MENU button to exit.

MENU SCREEN

TI ME R MOD E

S E T U P

: S E L E C T
S E T : E N T E R	ME NU : E X I T

•If you wish to change or cancel any settings, follow the procedures below.

CHANGING A RECORDING

1.Follow steps 1 to 3 of CHECKING A RECORDING above.

2.To change a delayed recording, press

[ /		] to highlight the recording, then press
the SET		SET	button to select.
										1 / 2
3. Press[				DA T E		P R	S T AR T	S T OP
	/ ]to highlight the setting to be
				2 1 / 0 6 0 2 1 2 : 0 0 1 3 : 0 0 S P *
changed and correct it by using the[ / ]				- - / -	-	- -	- : - -	- : -	-	- - -
or the NUMBER BUTTONS.				- - / - -		- -	- : - -	- : - -		- - -
				- - / -	-	- -	- : - -	- : -	-	- - -

4.When all corrections are complete press the

SET

SET button to confirm, then press the

MENU button to exit.

CANCELLING A RECORDING

1.	Follow steps 1 to 3 of CHECKING A
	RECORDING above.
2.	To cancel a delayed recording, press								1 / 2
	[ / ]to highlight the recording to be		DA T E		P R	S T AR T	S T OP
	cancelled, then press CLEAR.		2 1 / 0 6 0 2 1 2 : 0 0 1 3 : 0 0 S P *
			- - / -	-	- -	- : - -	- : -	-	- - -
3.	Press the MENU	button to exit.	- - / - -		- -	- : - -	- : - -		- - -
			- - / -	-	- -	- : - -	- : -	-	- - -

NOTE:

•If there are some programmes to be recorded, do not forget to press TIMER ON/OFF button to return the VCR to Timer Standby mode.

www.sharp.co.uk/support

21