ADVANCED OPERATION
REMOTE CONTROL OPERATION OF TV
In addition to operating the VCR the remote control will also operate basic functions on TVs, including brands other than SHARP.
SETTING UP THE VCR REMOTE CONTROL TO OPERATE THE TV
1.Switch on the TV.
2.Press the TV button 
on the VCR
remote control to place it into TV mode. Hold down the 
STANDBY 
button on the VCR remote control then the
appropriate button for the TV from the list
shown, for 2 seconds. For example for a
SHARP TV, press 
STANDBY 
and
1.
3.The TV will enter standby mode to confirm the correct code has been entered.
4.Turn your TV on from standby mode in the usual way, e.g.,by pressing the standby or Channel up or down buttons.
TV BRAND | BUTTON | TV BRAND | BUTTON | ||
SHARP | 1 | TOSHIBA | 9 |
|
|
|
| ||||
PHILIPS | 2 | PANASONIC | 0 or |
|
|
THOMSON | 3 or 4 | HITACHI | INPUT SELECT | ||
GRUNDIG | 5 | SANYO | MODE OSD | ||
FERGUSON | 6 | JVC | DISPLAY | ||
ITT NOKIA | 7 | MITSUBISHI | AUDIO OUT | ||
SONY | 8 |
|
|
|
|
CONTROLLING THE TV WITH THE VCR REMOTE CONTROL
• | STANDBY |
| Switches the TV to and from Standby Mode. |
|
|
| (when the remote is in TV mode) |
• | INPUT SELECT |
| Determines which input to the TV is to be |
| |||
| |||
|
|
| displayed on the Screen. (when the remote is in TV |
|
|
| mode) |
• | CHANNEL |
| Changes the TV channels. (when the remote is in |
|
|
| TV mode) |
• | VOLUME |
| Increases or decreases the volume. |
NOTES:
•Certain models of TV do not use standard codes for their brand. In this case, place the
remote into TV mode and then hold down 
STANDBY 
. Press each of the buttons in the list until the TV enters
control batteries are replaced).
•SHARP cannot guarantee the VCR remote control will operate your TV.
www.sharp.co.uk/support
29