INSTALLING YOUR VCR
AUTO INSTALLATION OF A SATELLITE RECEIVER/ CABLE BOX CONTINUED
12.Press[
/
]to select SAT NO.
•Sky Digital Installation
If you wish to install the preset Sky Digital receiver channel list, enter the code 035. While the arrows on the screen are moving from VCR to SAT a test signal of channel 012 is being sent out from the VCR. Please ensure your Sky Digi box responds to this signal (“012 channel unavailable” will appear on the screen). A list of preset digital channels can be found at the back of the operation manual.
•Other Analogue Satellite Systems
Refer to the table at the end of this manual. Look for the make of your satellite receiver and use the NUMBER BUTTONS to enter the first code number listed. For example number 8 should be entered 0 0 8. Your satellite should now change to preset channel 12.
NOTES:
•If your satellite receiver has not changed to preset channel 12 enter the next code number on the list. Continue until the receiver shows preset channel 12, then continue from point 13.
•If your satellite receiver is not in the manufacturers list or after entering all the numbers
listed for your receiver, the receiver preset channel has still not changed to 12, enter 001
and check your receiver. If it has not changed press 
to select 002 and
•If there is still no response, try adjusting the position of your satellite receiver.
13.Once your Satellite Receiver has responded to the VCR press the SET SET button to continue.
The VCR will attempt to copy the TV preset list (NexTView, Smart Link, Easy Link and Megalogic compatible TV’s only). During the copying process the display will show the TV presets that are being copied. If the VCR is unable to copy the TV preset list the terrestrial and satellite channels will be automatically installed. (Auto install may take a few minutes.)
REMOTE
SET
MENU SELECT
BUTTONS
See next page to continue 
If you connect a Satellite Receiver to the VCR for the first time, after
RECEIVER / CABLE BOX INSTALLATION.)
www.sharp.co.uk/support
10