Sharp VC-MH835HM ON-SCREEN Display, FULL, all the active features will also be shown on screen

TINS-A082UMN1.book Page 43 Monday, November 4, 2002 2:33 PM

MORE INFORMATION ABOUT YOUR VCR

ON-SCREEN DISPLAY

All the information you need on the VCR status will be summarised on the on-screen display.

If you are recording, playing back a tape or watching a broadcast on the video channel you

can call up three standard on-screen displays. The display can be selected by pressing the

MODE OSD button on the remote control, 1,2,3 or 4 times.

1.AUTO, the current mode and channel number will be displayed for 3 seconds when an operation or number button is pressed.

1.

■	1 CH 5 9
	N I CAM
	S T E R EO
S P	L R

2. FULL, all the active features will also be shown on screen.

2.

Programme number and channel
Tape Status			■				1 CH 5 9
NICAM signal			S U P E R P .	ON			N I CAM
Audio output mode							S T E R EO
			S P					L R
Tape speed
		2 2 : 0 0			R
Tape remaining						EM1 : 0 5
	9 / 0 7 0 2				0 : 0 0 . 0 0
Time
Date
Tape counter

3.COUNTER, this display will show the tape

counter and amount of tape remaining. 3.

4.DISPLAY OFF, this will remove the display from the screen.

R EM1 : 0 5

0 : 0 0 . 0 0

NOTES:

•The default time and date will not be displayed if the clock has not been set.

•The VCR will return to display 1. each time it is switched on.

•If you are recording from this VCR to another, make sure you remove the display from the screen otherwise it will be recorded.

www.sharp.co.uk/support

43