Sharp PGLW2000, PG-LW2000 Adjusting the Projected Image SCR-ADJ Menu, Setting the Resize Mode

Adjusting the Projected Image (“SCR-ADJ” Menu)

Menu operation n Page 36

	Pict.	SIG	SCR-ADJ PRJ1	PRJ2
1	Resize		Normal
2	Image Shift		0
3	Keystone		0
4	Overscan		On
5	OSD Display		On
6	Closed Caption		Off
7	Background		Logo
8	Setup Guide		On
9	PRJ Mode		Front
0	Wall Color		Off
	Language		English
	SEL./ADJ.		ENTER		END

1 Setting the Resize Mode

Use this function to stretch the image vertically or horizontally or when the edges of the image cannot be seen.

Note

•For details of the Resize mode, see pages 28 and 29.

•You can also press RESIZE on the remote control to set the Resize mode. (See page 28.)

3 Keystone Correction

When the image is projected either from the top or from the bottom towards the screen at an angle, the image becomes distorted trapezoidally. The function for correcting trapezoidal distortion is called Keystone Correction.

Select “Keystone” on the “SCR-ADJ” menu and adjust with the slide bar.

See page 26 for details of Keystone Correction.

Q button O button

2 Adjusting the Image Position

You can move the projected image vertically.

O button Q button

Note

•This function only works in some Resize modes. (See pages 28 and 29.)

Note

•The Keystone Correction can be adjusted up to an angle of approximately ±40 degrees (When the Resize mode is set to “NORMAL”).

•You can also press KEYSTONE on the remote control to adjust Keystone Correction.

Features Useful

43