Sharp DV-NC70W, DV-NC70 and DV-NC70X Adjusting the Video Channel, 19 GB, RF pattern

Adjusting the Video Channel

To view the output of your Product on the television screen, you must select an unused channel on your TV and tune it to the output of your Product (see Table 1 for factory preset to UHF Channel).

1 Make sure both Products (TV and this Product) are connected (power cord) to the power outlet.

2 Turn on your TV.

3 Select an unused channel on your TV.

OPERATE ON/OFFTIMER

ON

DISPLAY SCREEN

DV- NC70W

DV- NC70

DV- NC70X

EJECT

VCR/DVD VCR MENU SELECTOR DVD SETUP

G-CODE

PROG

4 Set the power on the Product to off. (If the Product is ON, press OPERATE to turn off the power.)

5 Keep pressing VCR MENU for more than two seconds to light up the UHF Channel (see Table 1) on the VCR Front Panel display.

Table 1

		Factory Preset UHF Channel
	South East Asia,	60
Ex.	Hong Kong
	Australia	37

6 Adjust the tuning of the selected TV channel until the RF pattern appears on your TV screen. (Refer to your Operation Manual for tuning procedures.)

RF	DV-NC70W and
SYSTEM I B/G D/K	DV-NC70 only

(RF pattern)

RF	DV-NC70X only
SYSTEM B/G D/K

(RF pattern)

FUNCTION	PROG/	ANGLE	OPEN/
CONTROL	REPEAT		CLOSE
TITLE			DVD MENU
CLEAR			SET
RETURN			ENTER
			ZERO BACK
			SKIP SEARCH
AM/PM	INPUT SELECT VCR DVD
/
REV			FWD
	PLAY
REC			PAUSE/STILL
	STOP
TAPE	DPSS		SLOW
SPEED	SKIP
CH		AUDIO
	OUTPUT
	VCR	DVD

VCR/DVD COMBINATION

19 GB