Sharp DV-NC70W, DV-NC70 and DV-NC70X Tape Dubbing Connection Instructions, 73 GB

Tape Dubbing

Tape Dubbing Connection Instructions

Your product can dub (copy) video material from another video device. It can also output video and audio signals for recording on other video or audio equipment. Audio/Video dubbing cannot be done separately.

OPERATE ON/OFFTIMER

ON

DISPLAY SCREEN

DV- NC70W

DV- NC70

DV- NC70X

EJECT

VCR/DVD VCR MENU SELECTOR DVD SETUP

G-CODE

PROG

1 Switch your product to the auxiliary input by pressing INPUT SELECT. “L1” lights up on the VCR Front Panel display. (You can also use CH ' / ".)

2 Begin recording on the dubbing VCR and playback on the source VCR simultaneously.

•When using special playback functions (still picture, video search, frame advance, and variable slow motion) during dubbing, a blue screen may appear.

Set BLUE SCREEN mode on the dubbing VCR (for recording) to OFF. (See Mode Selection on page 25.)

•Use an RCA pin–type connection cable (not supplied with VCR, but supplied with VIEWCAM) to connect source VCR to dubbing VCR.

•Refer to the manual of the VCR connected to this product when dubbing a tape.

•You can also use the front AV jacks. Select “L2” (Aux. 2 input) by pressing INPUT SELECT twice.

•If source VCR is a monaural mode, connect the audio cable to “AUDIO-L” of the dubbing VCR.

FUNCTION	PROG/	ANGLE	OPEN/
CONTROL	REPEAT		CLOSE
TITLE			DVD MENU
CLEAR			SET
RETURN			ENTER
			ZERO BACK
			SKIP SEARCH
AM/PM	INPUT SELECT VCR DVD
/
REV			FWD
	PLAY
REC			PAUSE/STILL
	STOP
TAPE	DPSS		SLOW
SPEED	SKIP
CH		AUDIO
	OUTPUT
	VCR	DVD

VCR/DVD COMBINATION

Sharp Viewcam (for playback)

Audio/Video cable (supplied with Viewcam)

DVD/VCR		VCR	DVD/VCR		VCR	AV 2 IN VIDEO L(MONO) - AUDIO-R
LINE OUT 1	LINE IN 1	ANTENNA IN	LINE OUT 1	LINE IN 1	ANTENNA IN
R	R		R	R	or
AUDIO	AUDIO		AUDIO	AUDIO
L	L	RF OUT	L	L	RF OUT	To Front
VIDEO	VIDEO		VIDEO	VIDEO
Source VCR					Dubbing VCR
(for playback)					(for recording)

73 GB