Sharp DV-NC70 and DV-NC70X, DV-NC70W operation manual Adjusting the Video Channel

Adjusting the Video Channel

7 Press \ / to select the RF output system that corresponds to your TV by referring to the chart shown to the below, and press SET.

		I,B/G,D/K (RF system)
	Hong Kong	I
Ex.	China, Russia	D/K
	South East Asia
	Australia	B/G
	New Zealand

8 Press OPERATE to turn on the power of the Product. Select any channel on the VCR tuner. If a picture appears and sound can

OPERATE ON/OFFTIMER

ON

DISPLAY SCREEN

DV- NC70W	G-CODE
DV- NC70	PROG
DV- NC70X

EJECT

VCR/DVD VCR MENU

SELECTOR DVD SETUP

be heard, then the RF output system is correctly set. If a picture appears but no sound can be heard, then perform step 7 above to select another RF output system.

•Make sure the sound is not muted when checking the RF output system.

•It is not necessary to change the system to RF system “M”. The Product will automatically detect and change the RF system to “M” when receiving the NTSC signal.

•If picture interference appears on the TV screen in step 6 above, you can change the video channel (RF output channel from the Product to TV) with the following procedure. If UHF Channel (see Table 1) is an active broadcast channel in your area, manually select a different channel (UHF 21 to UHF 69) (see below) and then retune your TV as

above.

1 Press OPERATE to turn off the power.

2 Keep pressing VCR MENU for more than two seconds to light up

the UHF Channel (see Table 1) on the VCR Front Panel display.

3 Press ' / " on the Remote to manually select an unused channel for use as the video channel.

4 Perform steps 6 to 7 above using the newly selected video

channel.

5 Repeat steps 3–4to select the optimal video channel.

FUNCTION	PROG/	ANGLE	OPEN/
CONTROL	REPEAT		CLOSE
TITLE			DVD MENU
CLEAR			SET
RETURN			ENTER
			ZERO BACK
			SKIP SEARCH
AM/PM	INPUT SELECT VCR DVD
/
REV			FWD
	PLAY
REC			PAUSE/STILL
	STOP
TAPE	DPSS		SLOW
SPEED	SKIP
CH		AUDIO
	OUTPUT
	VCR	DVD

VCR/DVD COMBINATION

GB 20