Precaución

IMPORTANT SAFETY INSTRUCTIONS

3D Glasses (for the UQ17U, TQ15U, SQ17U, SQ15U and LE657U models) Prevention of accidental ingestion

•Keep the accessory out of the reach of small children. Small children can accidentally swallow these parts.

– If a child accidentally swallows any of these parts, seek immediate medical attention.

Do not disassemble

•Do not disassemble or modify the 3D Glasses except when recycling the batteries. Do not modify the 3D Glasses.

Handling the 3D Glasses

•Do not drop, exert pressure on, or step on the 3D Glasses. Doing so may damage the glass section, which may result in the risk of injury.

•Be careful not to trap your finger in the hinge section of the 3D Glasses. Doing so may result in injury.

– Pay special attention when children are using this product.

Caution for lithium battery

•Batteries must not be exposed to excessive heat such as direct sunlight or fire.

•Replace only with the same or equivalent type of battery. The battery may explode if improperly replaced.

•Take care not to reverse the battery poles (+ and –) when loading the battery. Follow the correct procedure when loading the battery. Loading the battery incorrectly may damage the battery or cause it to leak battery fluid, which could result in a fire, injury or damage.

Using the 3D Glasses

•Use of the 3D Glasses should be limited to a maximum of 3 hours, and in any case no more than one movie.

•Use only the 3D Glasses recommended for this TV.

•Use the 3D Glasses only for the specified purpose.

•Do not move around while wearing the 3D Glasses. The surrounding area may appear dark, which may result in falling or other accidents that may cause injury.

Caring for the 3D Glasses

•Use only the cloth provided with the 3D Glasses to clean the lenses. Remove dust and soil from the cloth. Any dust or other soiling on the cloth may result in scratches. Do not use solvents such as benzene or thinners as doing so may cause the coating to peel off.

•When cleaning the 3D Glasses, take care not to allow water or other fluids to come into contact with the glasses.

•Always store the 3D Glasses in the case provided when not in use.

•When storing the 3D Glasses, avoid very humid or hot locations.

Viewing 3D images

•If you experience dizziness, nausea, or other discomfort while viewing 3D images, discontinue use and rest your eyes.

•Do not use the 3D Glasses if they are cracked or broken.

Notes on Radio Wave Certification in the U.S.A. and Canada

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

"This transmitter must not be co-located or operated in conjunction with any other anntenna or transmitter."

FCC/INDUSTRY CANADA NOTICE

This device complies with Part 15 of FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.

This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency (RF) Exprosure rules. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption ratio (SAR).

FCC CAUTION

Changes or modifications not expressly approved by Hosiden responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003

Le présent appareil est conforme aux la prtie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'uitilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Cet équipement est conforme aux limites d'exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d'exposition dans le Supplément C

àOET65 et d'exposition aux fréquences radioélectriques (RF) CNR-102 de l'IC. Cet équipement émet une énergie RF très faible qui est considérée conforme sans évaluation du débit d'absorption spécifique (DAS).

Cet appareil numérique de la classe B est conforme à la norme NMB-3 du Canada.

Notas sobre la Certificación de Radiodifusión en México

• COFETEL: RCPHOAR12-1504

• Nombre de la marca del módulo con licencia: SHARP CORPORATION

• Nombre de modelo del módulo con licencia: ARC0517

• Módulo ARC0517 instalado adentro de esta gafas

"La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada."

	Número de licencia para la certificación de radiodifusión
Estados Unidos	CONTAINS FCC ID: VIYARC0517
Canadá	CONTAINS IC: 7305A-ARC0517