Sony SAT-B3 operating instructions Setting the Security Code SAT-A4 Only

CODE CODE 001 CODE 002 CODE 003 CODE 004

3 Select OK to save your changes and return to the Setup Menu.

4 Go to “Step 2: Set the Remote Control’s RF Security Code” on page 73 to continue.

REMOTE CODES

Select REMOTE CONTROL from the Setup Menu.

Setting the Security Code (SAT-A4 Only)

The Digital Satellite Receiver and remote control are shipped with the RF security code set to 000.

If the Digital Satellite Receiver is accepting or receiving signals from another RF remote control in your home (or from a neighbor’s house), you can eliminate this problem by changing the security codes for the Digital Satellite Receiver and remote control.

Note

As an alternative, you can eliminate this problem by disabling the RF capability of the Digital Satellite Receiver, if you have no need for RF transmission. See “Selecting IR/RF Transmission (SAT-A4 Only)” on page 71 for details.

There are two steps to changing the RF security code: Step 1 is changing the Digital Satellite Receiver’s security code; step 2 is changing the remote control’s security code. Both the Digital Satellite Receiver and the remote control must use the same three-digit security code.

Step 1: Select the Digital Satellite Receiver’s RF Security Code

1

2 Select RF SECURITY CODE and then select a different security code.

SET UP REMOTE
					OK
	REMOTE SIGNAL	IR ONLY
					CANCEL
	RF SECURITY CODE		000	RF SECURITY CODE	IDENTIFY
				Select the RF security
					HELP
				code for the Digital
				Satellite Receiver.

72