Sony SAT-A4 Set the Remote Control’s RF Security Code, Select OK to return to the Setup Menu

To Determine the Current Security Code for the Remote Control (SAT-A4 Only)

Step 2: Set the Remote Control’s RF Security Code

1 Press the CODE SET button on the remote control.

2 Using the number buttons on the remote control, enter the three- digit security code you selected for the Digital Satellite Receiver in step 2 on page 72.

3 Press the ENTER button on the remote control.

The RF security code is now changed for both the Digital Satellite Receiver and remote control.

You can determine the current RF security code for the remote control using the IDENTIFY button in the Set Up Remote screen.

1 Bring up the Set Up Remote screen, as described on page 71.

2 Select IDENTIFY.

SET UP REMOTE
	REMOTE SIGNAL	IR ONLY	OK
			CANCEL
	RF SECURITY CODE	000	IDENTIFY
			HELP
	REMOTE CODES
	Press the joystick within 5 seconds.

3 When the message “Press the joystick within 5 seconds” appears, press the joystick before the 5 seconds expire.

The current RF security code for the remote control appears.

SET UP REMOTE
REMOTE SIGNAL	IR ONLY	OK
		CANCEL
RF SECURITY CODE	000	IDENTIFY
		HELP
REMOTE CODES
Your remote is currently set at 000.

Note

If the message, “Security code could not be identified” appears, check to make sure that RF is enabled and that the RF antenna is connected properly. See “Selecting IR/RF Transmission (SAT-A4 Only)” on page 71.

4 Select OK to return to the Setup Menu.

73