Maintenance and Care
Lamp Replacement
When the life of the projection lamp of this projector | Top Control |
draws to an end, the Lamp replacement icon appears on |
|
the screen and LAMP REPLACE indicator lights yellow. |
|
Replace the lamp with a new one promptly. The timing |
|
when the LAMP REPLACE indicator should light is |
|
depending on the lamp mode. |
|
This indicator is yellow w h e n t h e l i f e o f t h e projection lamp draws to an end.
Lamp replacement icon
Note:
The Lamp replacement icon will not appear when the Display function is set to “Off” (p.47), during “Freeze” (p.23), or “No show” (p.24).
CAUTION
Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.
CAUTION
For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.
CAUTION
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.
If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.
Refer to the next page for replacing a lamp.
60