Panasonic VQT9958 operating instructions Display panel

CONTENTS

Parts and their functions

Display panel

											1									2			34			5		6
																								SCH		SERVO
			625									REMOTE							VIDEO			AUDIO
dB			dB			dB			dB										Y PB PR			ANALOG				=			INH
0			0			0			0					CUE					CMPST			AES/EBU					EDIT REC			7
-4			-4			-4			-4				dB						SDI		USER SET			DVCPRO
-8			-8			-8			-8		-8											SDI
																									50
-12			-12			-12			-12		-12							SDTI/1394			SDTI/1394
																								DVCAM
																			SG 1 2			SG
-16			-16			-16			-16		-16
-20			-20			-20			-20		-20
-25			-25			-25			-25		-25					CTL
-30			-30			-30			-30		-30
																		TC
-			-			-			-		-
																	UB
	L	R		L	R		L	R		L		R		L	R

1REMOTE lamp

This lamp lights when the CONTROL switch has been set to the REMOTE position.

2INPUT SELECT display area

The characters corresponding to the selected input signals light. With all input signals except for analogue audio signals, the fact that no signals have been selected is indicated by a flashing

display.

VIDEO

Y PB PR	: Analogue component video signals
	(option)
CMPST	: Analogue composite video signals
	(option)
SDI	: Serial digital video signals
SDTI/1394	: Compressed digital signals (option)
SG/SG 1/SG 2: Internal reference signals
AUDIO
ANALOG	: Analogue audio signals
AES/EBU	: Digital audio signals
USER SET	: Recording audio signal selection
SDI	: Serial digital audio signals
SDTI/1394	: Compressed digital signals (option)
SG	: Internal reference signals

3= lamp

This lamp lights when a cassette tape is inserted into the VTR.

4SCH lamp

This lamp lights when the SCH phase of the external synchronized signal (REF VIDEO) is inside the prescribed range.

At all other times, the lamp is off.

5SERVO lamp

This lamp lights when the drum servo or capstan servo locks.

6Channel condition lamps

These lamps light to indicate the error rate status. (green 5 white 5 red)

Green: This lights when the error rates for the video and audio playback signals are both at acceptable levels.

White : This lights when the error rate for the video or audio playback level has increased.

The playback picture and sound remain unaffected even while this lamp is lit.

Red : This lights when the error rate for the video or audio playback level has increased to the extent that correction or interpolation was performed.

7EDIT, EDIT REC, REC and REC INH lamps EDIT:

This lights when an editing mode has been selected.

EDIT REC:

This lights when the edit recording mode has been established.

REC:

This lights when the recording mode has been established.

REC INH:

This lights in the recording inhibit status (when the REC INH switch at the bottom front panel is set to ON or the cassette is in the accidental erasure prevention status).

In this status, recording and editing are not possible.

Whether the REC INH lamp is to light or flash when recording has been inhibited by the accidental erasure prevention tab on the cassette tape can be selected using setup menu No. 114 (REC INH LAMP).

12 (E)