Panasonic VQT9958 Reel Rota VTR Stop TOO Fast, Torque ERR VTR Stop, CAP Tension, Reel DIR, Drum

CONTENTS

Error messages

Error messages

Display	ODescription
	OVTR operation and corrective action
E-64	If the supply reel motor speed is abnormally
	high, the error number flashes on the display.
S REEL ROTA	VTR: STOP
TOO FAST	OSet the POWER switch to OFF and then to
	ON again.
E-67	If the take-up reel motor speed is abnormally
	high, the error number flashes on the display.
T REEL ROTA	VTR: STOP
TOO FAST	OSet the POWER switch to OFF and then to
	ON again.
E-69	If excess torque being applied to the take-up
	reel motor is detected, the error number flashes
T REEL	on the display.
TORQUE ERR	VTR: STOP
	OSet the POWER switch to OFF and then to
	ON again.
E-70	If excess torque being applied to the supply reel
	motor is detected or an abnormal current flowing
S REEL	to the current detection resistor is detected, this
TORQUE ERR	error number flashes on the display.
	VTR: STOP
	OSet the POWER switch to OFF and then to
	ON again.
E-71	If abnormal tension at the supply side is
	detected in the capstan mode, the error number
CAP TENSION	flashes on the display.
ERROR	VTR: STOP
	OSet the POWER switch to OFF and then to
	ON again.
E-72	If abnormal tension at the supply side is
	detected in the reel mode, the error number
REEL	flashes on the display.
TENSION	VTR: STOP
ERROR	OSet the POWER switch to OFF and then to
	ON again.
E-73	If the take-up reel motor has rotated in the
	reverse direction, this error number flashes on
REEL DIR	the display.
UNMATCH	VTR: STOP
	OSet the POWER switch to OFF and then to
	ON again.
E-74	If excess torque being applied to the cylinder
	motor is detected, this error number flashes on
DRUM	the display.
TORQUE	VTR: STOP
ERROR	OSet the POWER switch to OFF and then to
	ON again.
E-78	If a problem has been encountered in
	communication	between	the	servo
M-IF COMM	microcomputer and mechanism relay board, this
ERROR	error number flashes on the display.
	VTR: STOP
	OSet the POWER switch to OFF and then to
	ON again.

Consult your dealer if the error message is still displayed even after restarting the unit.

66 (E)