CONTENTS
Parts and their functions
Rear panel
AC IN
SIGNAL
GND
AES/EBU |
| ANALOG | |
CH1/2 |
|
| VIDEO |
IN |
|
| |
|
|
| IN |
|
|
| ON |
CH3/4 | Y |
| 75Ω |
|
|
| |
IN |
|
| OFF |
CH1/2 | PB |
| REF VIDEO |
OUT |
|
| IN |
|
|
| ON |
CH3/4 | PR |
| 75Ω |
OUT | OPTION |
| OFF |
| Y | 1 | VIDEO |
|
|
| OUT |
PB2 (WFM)
PR3 (SUPER)
SERVICE ONLY
REMOTE 
REMOTE IN/OUT
REMOTE OUT
ENCODER REMOTE
PARALLEL
| ANALOG |
|
| |
CH1 PUSH AUDIO PUSH CH2 | PUSH | TC | ||
| IN |
|
| IN |
CH3 PUSH |
| PUSH CH4 |
| TC |
|
|
|
| OUT |
CH1 | AUDIO | CH2 |
| MON |
| OUT |
|
| L |
CH3 |
| CH4 |
| MON |
|
|
|
| R |
| SDI |
IN | OUT |
1
ACTIVE
THROUGH
2
3
(SUPER)
OPTION
SDTI
IN OUT
1
2
APARALLEL REMOTE connector
This connector is used when the VTR is to be operated by an external component.
BANALOG AUDIO OUT connectors
The analogue audio signals are output through these connectors.
= <
> ?@ A B C D
CMONITOR OUT connectors
During playback, the PCM audio signals (CH1/CH2/CH3/CH4) or playback signals from the CUE track are output through these connectors.
<Fan
This fan is used to cool down the VTR.
If, for any reason, the fan stops,
=SIGNAL GND terminal
This is connected to the signal ground terminal on the component connected to this VTR in order to minimize noise. It is not a safety ground.
>ANALOG COMPONENT VIDEO OUT connectors The analogue component video signals are output through these connectors.
?ANALOG COMPOSITE VIDEO OUT connectors The analogue composite video signals are output through these connectors.
The waveform monitor (WFM) signal can be output from the VIDEO OUT 2 connector.
It can be selected using setup menu No. 00 (WFM SEL).
Video signals containing superimposed information can be output through the VIDEO OUT 3 connector. Whether the superimposing is to be set ON or OFF is selected using the SUPER switch W on the front panel.
@RS-232C connector
A personal computer or other component can be connected to this connector to operate the VTR.
DSDTI input and output connectors (optional) When the SDTI board
15 (E)