Marantz MV5100 manual Automatic Channel Setup, Press the VCR button, then press the Menu button

MV5100 04-26 7/21/00 10:58 AM Page 12

12 Automatic Channel Setup

Although your VCR may automatically memorize the channels you receive when you turn it on for the first time, this function lets you set up channels again. Make each entry within one minute of the previous entry.

1

Press the VCR button, then press the MENU button.

5 Wait for the VCR to set up channels.

1

SAT/

CBL/DBS TV VCR

VCR/TV POWER SMARTPICTURE

➔VCR SET UP TUNER SET UP INITIAL SET UP TAPE MANAGER

SELECT: 89	CONFIRM: OK
END: MENU

2

Press the PLAY 8 or STOP 9 button to select TUNER

SET UP, then press the OK/STATUS button.

➔ CABLE/ANTENNA		CABLE
AUTO CH. PROGRAMMING
ADD/DELETE CH.
SELECT: 89	CHANGE: '
END: MENU

3

Press the FF - button repeatedly so that ANT (if you have an antenna) or CABLE (if you have a cable connec- tion) appears beside CABLE/ANTENNA.

4

Press the STOP 9 button to select AUTO CH. PRO- GRAMMING, then press the OK/STATUS button. AUTO CH. SET PROCEEDING PLEASE WAIT and a scale that shows the progress of channel setup will appear on the screen.The VCR will memorize all the channels you receive.

5

Wait for a few minutes while the VCR sets up channels. When programming is complete,AUTO CH. SET COMPLETED will appear on the screen.Then, the programming of the lowest channel number placed in the VCR’s memory will appear on the screen. Now when you press the CH(annel) 8/9 button, you will scan only through channels you receive.

		QUICK PROGRAMMING
	1– +*		+ 2 ABC + 3 DEF
	START		STOP		DATE
	4 GHI - 5 JKL - 6 MNO
	VPS/PDC		DAILY		WEEKLY
	7PQRS		8 TUV		9WXYZ
	SPEED		DBS/SAT
	ALT		0		CLEAR
	-		STILL/SLOW			+
		..........		..........
	REW					FF
			PLAY			3
2,4			STOP
	VOL		OK/STATUS			CH
			MENU
1			TIMER
	TURBO	AUDIO/		SKIP		TAPE
	TIMER	MUTE		SEARCH MANAGER
	JOG/SHTL					REC /OTR
	REV					FWD

Helpful Hints

•The two Line Input modes will always be stored in the VCR’s mem- ory at channel 00.To select A/V IN FRONT or A/V IN REAR, press 0, 0 so that A/V IN appears briefly, then press the CH(annel) 8/9 button so that A/V IN FRONT or A/V IN REAR appears on the screen briefly.To exit Line Input mode, use the CH(annel) 8/9 button to select a channel other than 00.

•The VCR may automatically set CABLE or ANT even if you do not select it.