Marantz MV5100 manual Introduction, Positioning, For Customer Use

Page 2

MV5100 02-3 7/21/00 10:56 AM Page 1

SAFETY PRECAUTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This “bolt of lighting” indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering.

Introduction

Congratulations on purchasing your new VCR.

You can’t wait to get it working, but before you do, spare a few moments to read this brief introduction to the world of video recording. It may repay you hand- somely in terms of improved results, and avoiding of costly mistakes.

This “exclamation point” calls attention to features for which you should read the enclosed literature closely to prevent operating and maintenance problems.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.

Positioning

Do not place the VCR directly on top of, or underneath, your TV set. Ensure that there is at least 20 cm between the VCR and the TV set, and that air can circulate freely through the ventilation openings of the VCR.

CAUTION:

To prevent electrical shock, match wide

 

blade of plug to wide slot, and fully insert.

ATTENTION: Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pouss er jusqu’au fond.

FCC Warning: Any unauthorized changes or modifications to this equipment void the user’ authority to operate it.

For Customer Use

Enter below the Serial No. which is located on the rear of the cabinet.

Retain this information for future reference.

Model No.

Serial No.

Image 2
Contents Model MV5100 User Guide For Customer Use IntroductionPositioning To prevent electrical shock, match wideIntroduction FeaturesSafety Precautions Declaration of Conformity Repeat PlayTable of Contents VCR Maintenance/Video Head Cleaning Putting Batteries in the Remote ControlUsing the Remote Control Replace the battery compartment lidHookups without a Cable Box Disconnect the antenna or cable from your TVTV OUT Hookups without a Cable Box cont’dANT Cable Recording/Viewing Any Channel Hookups with a Cable Box/Direct Broadcast SystemConnections Recording One Channel/Watching Another 1Cable signalConnect a Cable signal to the VCR’s Antenna in jack 2RF coaxial cableMenu shown below will appear Press the VCR button, then press the Power buttonTurning on Your VCR Turn on the TVSAT CBL/DBS TV VCR VCR/TV Power Smartpicture MenuAutomatic Channel Setup Press the VCR button, then press the Menu buttonPress the Play 8 or Stop 9 button to select Automatic Channel Setup cont’dAdding/Deleting Channels ADD/DELETE CH., then press the OK/STATUS buttonChannels are set up. Details are on Setting the ClockManual Clock Setting To make corrections, follow stepsDay increments Press the Play 8 or Stop 9 button repeatedly to setDate month and day. Every time you press the Play Setting the Clock cont’d Time Zone SelectionManual PBS Channel Selection VOL OK/STATUS MenuAutomatic PBS Channel Selection SAT CBL/DBS VCRPower Smartpicture Daylight-Savings TimeLanguage Selection Press the Play 8 or Stop 9 button to select LANDisplay Panel Front Panel Rear Panel TV Button VOLume 8/9 ButtonPower Button Play 8 ButtonSAT/CBL/DBS Button Timer ButtonTurbo Timer Button ALTernate Channel/SPEED ButtonIf on Screen Mode is set to on or Press the Play 8 or Stop 9 button to select onRepeat step 7PQRSFind the code for your SAT CBL/DBS VCR VCR/TV PowerTurn on your Cable Box/DBS Read and follow the steps below to play a tape Playback options and features are on pagesPlaying Press the VCR button VCR records in a preset volumeRecording Appear on the display panelVHS Recording VCR SET UP menu will appearVOL OK/STATUS Menu Timer VHS ET Recording One Channel/Watching Another VCR light will disappear from the display panelStarting an OTR Channels are set up. Details are on pagesOne-Touch Recording Record Link 1Set the program on the DBS Insert a tape in the VCRCall Letters Setting Up the VCR Plus+ Programming SystemChannels Setting Up the VCR Plus+ Programming System cont’d Timer Recording with the VCR Plus+ Programming System If you forget to turn off the VCR To check your timer recordings, seeTime every week Channels are programmed. Details are on pages CBL/DBS VCR VCR/TV PowerQuick Programming Cassette type / Playback Time Instructions continue onTape Speeds Tape Speed T160 T120 T60Quick Programming cont’d Will appear on the screen. If Program not Completed Press the OK/STATUS or Timer button. Program WASPress the Power button to turn off the VCR. The r light Appears, try again from stepTurbo Timer Insert a tape 1into the VCRIndicates a Weekly recording Checking, Editing, or Clearing Timer RecordingsProgram Review Indicates a Daily recordingBe highlighted in red Or, to cancel the timer recording, press the Clear buttonProgram Overlap Warning Press the OK/STATUS button to select the programTimer Recording Speed Setting Follow the steps below to set Timer REC Speed to AutoAudio and video cables are not included Rerecording Tape DuplicationVCR 1 will play your tape. Insert a prerecorded tape in VCR Audio-dubbed tape Audio DubbingPre-recorded tape Connecting the Controller Use an RF coaxial cable toInstructions continue on On pagesTurn on the Cable Box. Select a channel other than GHISetting the Controller to Operate a Cable Box cont’d Wait for a few secondsSetting the Controller to Operate a DBS SAT CBL/DBS TV VCR Setting the Controller to Operate a DBS cont’d7Wait for a few seconds Receiving a Second Audio Program Multi-Channel Television Sound SystemReceiving a Stereo Broadcast Multi-Channel Television Sound System cont’d Record the program as usual. Details are onHi-Fi Stereo Tape Playback Video Stabilizer Special effects playbackSmartPicture Digital Studio Picture Control Dspc does not work during a Record LinkSkip Search Press the Stop 9 button to cancel a Skip SearchIndex Search Viewing a Still Picture Playback OptionsForward and Reverse Searching Viewing a Slow Motion PictureViewing Picture in Slow to Fast Motion LightFind a Title How to read the Tape Manager Directory ScreenTape Manager Insert a tape recorded with this VCRTo check memory Check Memory screen appearsTape Manager To Edit Tape Title and/or Program Title Title EditingEntering Character Choice of CategoryIf no cassette is inserted in the VCR Tape Manager To Find a Desired ProgramSorting by Number Smartpicture Sorting by DateCBL/DBS VCR/TV CBL/DBS TV VCR VCR/TV Power Smartpicture Sorting by CategoryTape Manager To Find a Blank Space cont’d If you do not want to keep data of a particular tape Tape Manager To Delete Tape from Program DataDelete Tape Data Delete Program DataTape Manager To Disable Functions Menu screen appearsCL will blink on the display panel When Child Lock is activatedChild Lock CL will disappear from the display panelBlue Background Automatic Operation Features Glossary Cable Box/DBS Output Channel channel 03 orHelpful Hints Helpful Hints cont’d Specifications Volume 8/9 button Remote controlTimer AutomaticIs a registered trademark